HardLabs

GeO-Pad

gutierrezcortesedgar76-max·GeO-Pad

GeO-Pad

About the GeO-Pad PCB

GeO-Pad is an open source RP2040/RP2350 PCB design by gutierrezcortesedgar76-max, published on GitHub under the GPL-3.0 license. It is a board, with 8 components from 4 distinct parts.

Its main chip is the RP2040_Pro_Micro, from the RP2040/RP2350 family. By type, the board carries 3 switches, 3 diodes, 1 IC and 1 connector.

It belongs with the keyboards and displays & leds designs in this gallery.

From the project

A 3 key macropad with a pet that you can see while playing Geometry Dash or use for other things

Main components on the GeO-Pad

RP2040_Pro_Micro

GeO-Pad bill of materials (BOM)

8 components, 4 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
RP2040_Pro_Micro
U1
1
OLED_128x64
J2
3
—
S1, S2, S3
3
—
D1, D2, D3

GeO-Pad design files

The KiCad project lives in the gutierrezcortesedgar76-max/GeO-Pad repository on GitHub; these links point at the commit this page was built from.

GeO-Pad: common questions

What microcontroller does the GeO-Pad use?

The GeO-Pad is built around the RP2040_Pro_Micro, from the RP2040/RP2350 family.

How many components are on the GeO-Pad?

8 components, from 4 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the GeO-Pad design files?

From the gutierrezcortesedgar76-max/GeO-Pad repository on GitHub, which has the schematic and the BOM; the links under Design files point to each one.

Can I use the GeO-Pad design in my own project?

Yes, under the terms of its GPL-3.0 license, which gutierrezcortesedgar76-max chose for the repository.

Can I test firmware for the GeO-Pad without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

Similar boards