HardLabs

Incubator

Hackuarium·simple-i2c-screen·kicad/incubator/incubator.kicad_pcb

Incubator PCB layout, top view — open source AVR/Arduino board by Hackuarium

About the Incubator PCB

Incubator is an open source AVR/Arduino PCB design by Hackuarium, published on GitHub. It is a 2-layer board measuring 100 × 73.7 mm, with 34 components from 20 distinct parts.

Its main chip is the ATmega328P-AU, from the AVR/Arduino family. Other key parts include the LM78M05_TO252. By type, the board carries 10 resistors, 7 connectors, 7 diodes, 5 capacitors, 2 ICs and 1 switch.

It belongs with the displays & leds and power & battery designs in this gallery.

From the project

- Power supply plug: 5V to 28 V - Top-bottom 5 pin 2.54 mm connector. - 5 V buck converter - ATMEGA328P mmicrocontroller - ISP connector - LCD 16x2 display - RJ12 connector for I2C communication

Main components on the Incubator

LM78M05_TO252ATmega328P-AU

Incubator bill of materials (BOM)

34 components, 20 distinct parts.

QtyPartRefs
1
LM78M05_TO252
U1
1
ATmega328P-AU
U2
1
Barrel_Jack_MountingPin
J1
1
Conn_01x06
J2
4
Conn_01x01
J3, J5, J6, J7
1
RJ12
J4
1
WC1602A
DS1
1
10k
RV1
1
Rotary_Encoder_Switch
SW2
2
RED
D1, D2
3
MBR0520LT
D3, D4, D5
2
GREEN
D6, D7
1
0.33u
C1
3
100n
C2, C6, C7
1
10u
C5
3
10k
R1, R2, R3
3
1k
R4, R9, R10
1
100k
R5
1
0
R6
2
100
R7, R8

Incubator design files

The KiCad project lives in the Hackuarium/simple-i2c-screen repository on GitHub; these links point at the commit this page was built from.

Incubator: common questions

What microcontroller does the Incubator use?

The Incubator is built around the ATmega328P-AU, from the AVR/Arduino family.

How big is the Incubator PCB?

The Incubator measures 100 × 73.7 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Incubator?

34 components, from 20 distinct parts. The full bill of materials is listed on this page.

Where can I download the Incubator design files?

From the Hackuarium/simple-i2c-screen repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Incubator design in my own project?

The repository has no license, so all rights stay with Hackuarium. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Incubator without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in simple-i2c-screen

Similar boards