ShockGuard-CAD

HirthikBalaji·ShockGuard-CAD·Hardware/KiCad/ShockGuard_Carrier.kicad_pcb

ShockGuard-CAD PCB layout, top view — open source ESP32 board by HirthikBalaji

About the ShockGuard-CAD PCB

ShockGuard-CAD is an open source ESP32 PCB design by HirthikBalaji, published on GitHub. It is a 4-layer board measuring 30 × 22 mm, with 1 components from 1 distinct parts.

Its main chip is the ESP32-S3-WROOM-1-N16R8, from the ESP32 family.

It belongs with the power & battery designs in this gallery.

From the project

Parametric FreeCAD prototype of ShockGuard – automated capillary-refill / perfusion-index fingertip device for shock & sepsis triage (Vishwakarma Awards 2026–27). Concept, not validated.

Automated, skin-tone-calibrated capillary refill time (CRT) and Peripheral Perfusion Index (PPI) device for early shock and sepsis triage Vishwakarma Awards 2026–27 · Theme 8: Frontier Diagnostics – The Next Vital Signs

ShockGuard is a fingertip clip. A manually cocked, spring-driven plunger presses a transparent window onto the fingertip pad. A camera and ring LED look through the same window to record the blanch-and-refill sequence, a MAX30102 measures PPG, an ESP32-S3 runs the on-device model, and an OLED shows the CRT, Perfusion Index and Shock Risk Score. There is no motor or servo.

ShockGuard-CAD, from the project README
From the project README

Main components on the ShockGuard-CAD

ShockGuard-CAD bill of materials (BOM)

1 components, 1 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
ESP32-S3-WROOM-1-N16R8
MCU ESP32-S3 Dual-Core 240MHz 16MB Flash 8MB PSRAM
Espressif Systems
U1

ShockGuard-CAD design files

The KiCad project lives in the HirthikBalaji/ShockGuard-CAD repository on GitHub; these links point at the commit this page was built from.

ShockGuard-CAD: common questions

What microcontroller does the ShockGuard-CAD use?

The ShockGuard-CAD is built around the ESP32-S3-WROOM-1-N16R8, from the ESP32 family.

How big is the ShockGuard-CAD PCB?

The ShockGuard-CAD measures 30 × 22 mm, has 4 copper layers and is 1.6 mm thick.

How many components are on the ShockGuard-CAD?

1 components, from 1 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the ShockGuard-CAD design files?

From the HirthikBalaji/ShockGuard-CAD repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the ShockGuard-CAD design in my own project?

The repository has no license, so all rights stay with HirthikBalaji. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the ShockGuard-CAD without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards