Fire detector

iarpan1·fire_detector

Fire detector PCB layout, top view — open source ESP32 board by iarpan1

About the Fire detector PCB

Fire detector is an open source ESP32 PCB design by iarpan1, published on GitHub. It is a 2-layer board measuring 90.5 × 61.5 mm, with 11 components from 11 distinct parts.

Its main chip is the ESP32-DEVKIT-V1, from the ESP32 family. By type, the board carries 5 connectors, 2 capacitors, 2 resistors, 1 IC and 1 switch.

It belongs with the sensors and iot & wireless designs in this gallery.

From the project

its a simple esp32 based fire dector

A standalone embedded fire and gas monitoring system emphasizing power integrity, RF-aware PCB layout, and deterministic real-time behavior using FreeRTOS.

The system integrates sensing, processing, and cellular communication on a single expansion PCB, enabling reliable operation without external network dependency.

Main components on the Fire detector

Fire detector bill of materials (BOM)

11 components, 11 distinct parts.

QtyPartRefs
1
ESP32-DEVKIT-V1
U1
1
gsm800l
J1
1
mq2
J2
1
flame sensor
J3
1
dh11
J4
1
Conn_01x02_Socket
J5
1
SW_DPST_x2
SW1
1
1000uF
C1
1
100uF
C2
1
10k
R1
1
20k
R2

Fire detector design files

The KiCad project lives in the iarpan1/fire_detector repository on GitHub; these links point at the commit this page was built from.

Fire detector: common questions

What microcontroller does the Fire detector use?

The Fire detector is built around the ESP32-DEVKIT-V1, from the ESP32 family.

How big is the Fire detector PCB?

The Fire detector measures 90.5 × 61.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Fire detector?

11 components, from 11 distinct parts. The full bill of materials is listed on this page.

Where can I download the Fire detector design files?

From the iarpan1/fire_detector repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Fire detector design in my own project?

The repository has no license, so all rights stay with iarpan1. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Fire detector without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards