Env monitor
ivan-jankovic·env-monitor·hardware/env-monitor.kicad_sch

About the Env monitor PCB
Env monitor is an open source ESP32 PCB design by ivan-jankovic, published on GitHub under the MIT license. It is a board, with 9 components from 7 distinct parts.
Its main chip is the ESP32 DevKit V1, from the ESP32 family. Other key parts include the DHT22 module. By type, the board carries 3 diodes, 3 resistors, 2 ICs and 1 switch.
It belongs with the iot & wireless and sensors designs in this gallery.
From the project
ESP32 + DHT22 environment monitor: firmware with offline buffering and retries, a Flask API on PostgreSQL, alarms with hysteresis and a live dashboard
An ESP32 with a DHT22 sensor measures temperature and humidity every 10 seconds and sends the readings over WiFi to a small Flask API. The API stores them in PostgreSQL, raises alarms when values leave their limits, and serves a live dashboard.
Scenario: a filament storage room needs temperature and humidity monitored continuously, with an alert when readings drift out of range, and with no data lost during network outages.
Main components on the Env monitor
Env monitor bill of materials (BOM)
9 components, 7 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | ESP32 DevKit V1 | U1 | |
| 1 | DHT22 module | U2 | |
| 1 | check button | SW1 | |
| 1 | LED green | D1 | |
| 1 | LED yellow | D2 | |
| 1 | LED red | D3 | |
| 3 | 220 | R1, R2, R3 |
Env monitor design files
The KiCad project lives in the ivan-jankovic/env-monitor repository on GitHub; these links point at the commit this page was built from.
- Schematichardware/env-monitor.kicad_sch
Env monitor: common questions
What microcontroller does the Env monitor use?
The Env monitor is built around the ESP32 DevKit V1, from the ESP32 family.
How many components are on the Env monitor?
9 components, from 7 distinct parts. The full bill of materials is listed on this page.
Where can I download the Env monitor design files?
From the ivan-jankovic/env-monitor repository on GitHub, which has the schematic; the links under Design files point to each one.
Can I use the Env monitor design in my own project?
Yes, under the terms of its MIT license, which ivan-jankovic chose for the repository.
Can I test firmware for the Env monitor without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.
Similar boards
ESP32
OSO-BOOK-B1
joeycastillo
85 × 115 mm65 parts2LCC-BY-SA-4.08.1kESP32
Powertrain
byrantech
64 × 45.4 mm171 parts4LMIT4.3kESP32
Badge
atopile
56.3 × 39 mm239 parts4LMIT4.0kESP32
Esp32 minimal
atopile
36.2 × 26.8 mm20 parts2LMIT4.0kESP32
Controller
StuckAtPrototype
29 × 74 mm58 parts4LApache-2.03.8kESP32
Racer
StuckAtPrototype
36 × 50.2 mm70 parts4LApache-2.03.8k