-usccpe

jjsnippets·-usccpe·CPE3201/Line Follower/line follower schematic.kicad_pcb

-usccpe PCB layout, top view — open source PIC board by jjsnippets

About the -usccpe PCB

-usccpe is an open source PIC PCB design by jjsnippets, published on GitHub. It is a 2-layer board measuring 75 × 90 mm, with 35 components from 19 distinct parts.

Its main chip is the PIC16F877A, from the PIC family. Other key parts include the LM7805 and TB6612FNG. By type, the board carries 11 capacitors, 7 diodes, 7 resistors, 4 connectors, 3 ICs and 1 crystal.

From the project

usc-bscpe compiled code

Main components on the -usccpe

-usccpe bill of materials (BOM)

35 components, 19 distinct parts.

QtyPartRefs
1
LM7805
U1
1
PIC16F877A
U2
1
TB6612FNG
U3
1
20MHz
X1
1
Screw_Terminal_01x02
J1
1
Conn_01x09
J2
2
Screw_Terminal_01x03
J3, J4
1
10k Trimmer
RV1
1
SW-SPDT
SW1
1
1N4007
D1
2
Green
D2, D3
2
Red
D4, D5
2
Yellow
D6, D7
2
10uF
C1, C2
3
100nF
C3, C10, C11
2
22pF
C4, C5
4
100uF
C6, C7, C8, C9
1
10k
R1
6
330
R2, R3, R4, R5, R6, R7

-usccpe design files

The KiCad project lives in the jjsnippets/-usccpe repository on GitHub; these links point at the commit this page was built from.

-usccpe: common questions

What microcontroller does the -usccpe use?

The -usccpe is built around the PIC16F877A, from the PIC family.

How big is the -usccpe PCB?

The -usccpe measures 75 × 90 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the -usccpe?

35 components, from 19 distinct parts. The full bill of materials is listed on this page.

Where can I download the -usccpe design files?

From the jjsnippets/-usccpe repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the -usccpe design in my own project?

The repository has no license, so all rights stay with jjsnippets. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the -usccpe without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug PIC firmware against it before you order a PCB.

Similar boards