HardLabs

Pet feeder rust project

JuverdeanuDianaMaria·pet-feeder-rust-project·kicad/pet_feeder.rust.kicad_pcb

This repository ships a schematic but no board layout.

About the Pet feeder rust project PCB

Pet feeder rust project is an open source RP2040/RP2350 PCB design by JuverdeanuDianaMaria, published on GitHub. It is a 2-layer board, with 4 components from 4 distinct parts.

Its main chip is the SC0918, from the RP2040/RP2350 family. By type, the board carries 2 modules and 1 switch.

It belongs with the displays & leds, power & battery and sensors designs in this gallery.

From the project

I grew up surrounded by pets at home, and one recurring challenge we faced as a family was planning vacations. We often had to limit our travel plans because it was difficult to find someone reliable to feed our pets while we were away. This inspired me to design a Smart Pet Feed

I grew up surrounded by pets at home, and one recurring challenge we faced as a family was planning vacations. We often had to limit our travel plans because it was difficult to find someone reliable to feed our pets while we were away. This inspired me to design a Smart Pet Feeder system built using a Raspberry Pi Pico 2W and Rust. The feeder dispenses food at scheduled times or remotely via wi-fi control. To make pet care more convenient and give pet owners more freedom and peace of mind when traveling.

Main components on the Pet feeder rust project

SC0918

Pet feeder rust project bill of materials (BOM)

4 components, 4 distinct parts.

QtyPartRefs
1
SC0918
A1
1
Motor_Servo
M1
1
Battery
5V
1
SW_Push
SW1

Pet feeder rust project design files

The KiCad project lives in the JuverdeanuDianaMaria/pet-feeder-rust-project repository on GitHub; these links point at the commit this page was built from.

Pet feeder rust project: common questions

What microcontroller does the Pet feeder rust project use?

The Pet feeder rust project is built around the SC0918, from the RP2040/RP2350 family.

How big is the Pet feeder rust project PCB?

The Pet feeder rust project has 2 copper layers and is 1.6 mm thick.

How many components are on the Pet feeder rust project?

4 components, from 4 distinct parts. The full bill of materials is listed on this page.

Where can I download the Pet feeder rust project design files?

From the JuverdeanuDianaMaria/pet-feeder-rust-project repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Pet feeder rust project design in my own project?

The repository has no license, so all rights stay with JuverdeanuDianaMaria. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Pet feeder rust project without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

Similar boards