Not a block

kryo-77·not-a-block·PCB/notablock.kicad_pcb

Not a block PCB layout, top view — open source ESP32 board by kryo-77

About the Not a block PCB

Not a block is an open source ESP32 PCB design by kryo-77, published on GitHub. It is a 2-layer board measuring 57.5 × 40 mm, with 15 components from 12 distinct parts.

Its main chip is the ESP32-C3_SUPERMINI_TH, from the ESP32 family. By type, the board carries 6 connectors, 4 resistors, 3 diodes, 1 IC and 1 capacitor.

It belongs with the audio and sensors designs in this gallery.

From the project

Note Block from Minecraft but in real life,

You can change the sound of the note block by placing it on different types of blocks as well. This is possible as there is an RFID card reader underneath the note block and a RFID tag on top of the instrument block (like stone, glass, sand, etc.)

There are 2 piezoelectric sensors present inside the note block's top and back surface. When you hit the surface, the piezo sends voltage to the ESP32's data pin which tells it to play the sound.

Not a block, from the project README
From the project README

Main components on the Not a block

Not a block bill of materials (BOM)

15 components, 12 distinct parts.

QtyPartRefs
1
ESP32-C3_SUPERMINI_TH
U1
1
RFID reader
J1
1
MAX98357A
J2
1
[HIT] Piezo
J3
1
[Pitch] Piezo
J4
1
Jumper
J5
1
5v ext
J6
1
1N5819
D1
2
BZX55C3V3
D2, D3
1
470uF
C1
2
1M
R1, R4
2
4.7k
R2, R3

Not a block design files

The KiCad project lives in the kryo-77/not-a-block repository on GitHub; these links point at the commit this page was built from.

Not a block: common questions

What microcontroller does the Not a block use?

The Not a block is built around the ESP32-C3_SUPERMINI_TH, from the ESP32 family.

How big is the Not a block PCB?

The Not a block measures 57.5 × 40 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Not a block?

15 components, from 12 distinct parts. The full bill of materials is listed on this page.

Where can I download the Not a block design files?

From the kryo-77/not-a-block repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Not a block design in my own project?

The repository has no license, so all rights stay with kryo-77. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Not a block without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards