HardLabs

Cage multigadget pi

limblab·proc-kevin·Kicad/cage_multigadget_pi/cage_multigadget_pi.kicad_pcb

Cage multigadget pi PCB layout, top view — open source Raspberry Pi board by limblab

About the Cage multigadget pi PCB

Cage multigadget pi is an open source Raspberry Pi PCB design by limblab, published on GitHub. It is a 2-layer board measuring 65.3 × 84.6 mm, with 29 components from 12 distinct parts.

Its main chip is the Raspberry_Pi_2_3, from the Raspberry Pi family. Other key parts include the OP495, MCP3004, AZ1117-3.3, MultigadgetDevice and LED_Button_connector. By type, the board carries 9 ICs, 6 transistors, 6 resistors and 4 connectors.

From the project

Kevin's analysis code

Main components on the Cage multigadget pi

OP495MCP3004AZ1117-3.3MultigadgetDeviceLED_Button_connector

Cage multigadget pi bill of materials (BOM)

29 components, 12 distinct parts.

QtyPartRefs
1
OP495
U1
1
MCP3004
U2
1
AZ1117-3.3
U3
2
MultigadgetDevice
U4, U5
4
LED_Button_connector
U6, U7, U8, U9
6
BSN20
Q1, Q2, Q3, Q4, Q5, Q6
1
USB_B_Micro
J1
1
Raspberry_Pi_2_3
J2
2
Conn_01x02
J3, J4
4
R_POT
RV1, RV2, RV3, RV4
4
1k
R1, R2, R5, R6
2
150
R20, R21

Cage multigadget pi design files

The KiCad project lives in the limblab/proc-kevin repository on GitHub; these links point at the commit this page was built from.

Cage multigadget pi: common questions

What microcontroller does the Cage multigadget pi use?

The Cage multigadget pi is built around the Raspberry_Pi_2_3, from the Raspberry Pi family.

How big is the Cage multigadget pi PCB?

The Cage multigadget pi measures 65.3 × 84.6 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Cage multigadget pi?

29 components, from 12 distinct parts. The full bill of materials is listed on this page.

Where can I download the Cage multigadget pi design files?

From the limblab/proc-kevin repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Cage multigadget pi design in my own project?

The repository has no license, so all rights stay with limblab. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Cage multigadget pi without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug Raspberry Pi firmware against it before you order a PCB.

More boards in proc-kevin

Similar boards