Tinygo rover workshop

logica0419·tinygo-rover-workshop·hardware/pcb/xiao-rv01β/xiao-rv01β.kicad_pcb

Tinygo rover workshop PCB layout, top view — open source ESP32 board by logica0419

About the Tinygo rover workshop PCB

Tinygo rover workshop is an open source ESP32 PCB design by logica0419, published on GitHub under the MIT license. It is a 2-layer board measuring 64.6 × 36.5 mm, with 23 components from 11 distinct parts.

Its main chip is the XIAO-ESP32-S3-Plus, from the ESP32 family. Other key parts include the MCP3208 and TPS61023DRLR. By type, the board carries 13 resistors, 3 ICs, 2 transistors and 1 diode.

From the project

TinyGo Rover Workshop 〜走れ!Tiny号

Main components on the Tinygo rover workshop

Tinygo rover workshop bill of materials (BOM)

23 components, 11 distinct parts.

QtyPartRefs
1
XIAO-ESP32-S3-Plus
U1
1
MCP3208
U2
1
TPS61023DRLR
MCP23S17
U4
2
P-Ch -12V/-6A
Q1, Q2
4
LBR-123F
SEN1, SEN2, SEN3, SEN4
1
TVS 5V
D1
2
100kΩ
R2, R19
3
22kΩ
R3, R8, R11
5
2.2kΩ
R9, R16, R17, R20, R23
1
33kΩ
R18
2
1kΩ
R21, R22

Tinygo rover workshop design files

The KiCad project lives in the logica0419/tinygo-rover-workshop repository on GitHub; these links point at the commit this page was built from.

Tinygo rover workshop: common questions

What microcontroller does the Tinygo rover workshop use?

The Tinygo rover workshop is built around the XIAO-ESP32-S3-Plus, from the ESP32 family.

How big is the Tinygo rover workshop PCB?

The Tinygo rover workshop measures 64.6 × 36.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Tinygo rover workshop?

23 components, from 11 distinct parts. The full bill of materials is listed on this page.

Where can I download the Tinygo rover workshop design files?

From the logica0419/tinygo-rover-workshop repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Tinygo rover workshop design in my own project?

Yes, under the terms of its MIT license, which logica0419 chose for the repository.

Can I test firmware for the Tinygo rover workshop without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards