Flightline motor controller

markGilchrist·flightline-motor-controller

Flightline motor controller PCB layout, top view — open source ESP32 board by markGilchrist

About the Flightline motor controller PCB

Flightline motor controller is an open source ESP32 PCB design by markGilchrist, published on GitHub. It is a 2-layer board measuring 92 × 76 mm, with 60 components from 41 distinct parts.

Its main chip is the Espressif ESP32-S3-WROOM-1-N8, from the ESP32 family. Other key parts include the TI LMR33630ADDAR, TI UCC27517ADBVR and ST USBLC6-2SC6. By type, the board carries 19 resistors, 18 capacitors, 8 diodes, 5 connectors, 4 ICs and 2 transistors.

It belongs with the robotics & motion and power & battery designs in this gallery.

From the project

A 92 × 76 mm two-layer board that runs a 12 V DC motor from a car battery (11–14.4 V). An ESP32-S3 sets the motor speed and adds pauses using PWM into a low-side MOSFET.

A 92 × 76 mm two-layer board that runs a 12 V DC motor from a car battery (11–14.4 V). An ESP32-S3 sets the motor speed and adds pauses using PWM into a low-side MOSFET.

- Input: 11–14.4 V car battery. Survives reverse battery (P-MOSFET Q1) and load-dump spikes (SMCJ20CA TVS clamps to about 32 V; everything on the 12 V side is rated 35–45 V). - Motor output: 12 V, up to 10 A continuous, fused at 15 A. Q2 (IPD90N04S4L-04, 3.8 mΩ) switches the motor's negative lead to ground, so the motor always sees full battery voltage scaled by the duty cycle. - PWM: 20 kHz (silent), 10-bit, from GPIO4…

Main components on the Flightline motor controller

TI LMR33630ADDARTI UCC27517ADBVREspressif ESP32-S3-WROOM-1-N8ST USBLC6-2SC6

Flightline motor controller bill of materials (BOM)

60 components, 41 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
TI LMR33630ADDAR
LMR33630ADDA
U1
1
TI UCC27517ADBVR
UCC27517A
U2
1
Espressif ESP32-S3-WROOM-1-N8
ESP32-S3-WROOM-1
U3
1
ST USBLC6-2SC6
USBLC6-2SC6
U4
1
Infineon IPD90P04P4L-04
IPD90P04P4L-04
Q1
1
Infineon IPD90N04S4L-04
IPD90N04S4L-04
Q2
1
Phoenix 1711026 (MKDS 3/2-5.08)
BATTERY 12V
J1
1
Phoenix 1711026 (MKDS 3/2-5.08)
MOTOR
J2
1
HRO TYPE-C-31-M-12
USB-C
J3
1
2.54 mm header
AUX
J4
1
Phoenix 1984617 (PT 1,5/2-3,5-H)
PARK
J5
1
Keystone 3568 + 15A mini blade fuse
15A
F1
1
E-Switch TL3342F160QG
RESET
SW1
1
E-Switch TL3342F160QG
BOOT
SW2
1
Littelfuse SMCJ20CA
SMCJ20CA
D1
2
BZT52C12
D2, D4
1
ST STPS20L45CG-TR
STPS20L45CG
D3
2
Diodes B360A-13-F
B360A
D5, D6
1
GREEN
D7
1
RED
D8
Show 21 more
QtyPartRefs
1
Bourns SRP7028A-6R8M
6.8uH
L1
2
Panasonic EEU-FR1V471
470uF 35V
C1, C2
4
X7R 1210
10uF 50V
C3, C4, C7, C8
1
1uF 25V
C5
4
100NF
100nF
C6, C10, C15, C17
1
100nF 50V
C9
2
1UF
1uF
C11, C16
2
X7R 1206
22uF 10V
C12, C13
1
10UF
10uF
C14
1
470NF
470nF
C18
4
10K
10k
R1, R3, R9, R10
1
10R
R2
1
220R
R4
2
100K
100k
R5, R6
3
1%
100k
R7, R13, R18
1
1%
43.2k
R8
2
5.1K
5.1k
R11, R12
1
1%
18k
R14
2
1k
R15, R16
1
4K7
4k7
R17
1
1%
10k
R19

Flightline motor controller design files

The KiCad project lives in the markGilchrist/flightline-motor-controller repository on GitHub; these links point at the commit this page was built from.

Flightline motor controller: common questions

What microcontroller does the Flightline motor controller use?

The Flightline motor controller is built around the Espressif ESP32-S3-WROOM-1-N8, from the ESP32 family.

How big is the Flightline motor controller PCB?

The Flightline motor controller measures 92 × 76 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Flightline motor controller?

60 components, from 41 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Flightline motor controller design files?

From the markGilchrist/flightline-motor-controller repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Flightline motor controller design in my own project?

The repository has no license, so all rights stay with markGilchrist. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Flightline motor controller without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards