HardLabs

My latexbook

mekatronik-achmadi·my_latexbook·Modul/KiCAD/example/esp32relay/esp32relay.kicad_pcb

My latexbook PCB layout, top view — open source ESP32 board by mekatronik-achmadi

About the My latexbook PCB

My latexbook is an open source ESP32 PCB design by mekatronik-achmadi, published on GitHub. It is a 2-layer board measuring 49.7 × 53.8 mm, with 18 components from 14 distinct parts.

Its main chip is the ESP32-WROOM-32, from the ESP32 family. Other key parts include the AMS1117-3.3. By type, the board carries 7 resistors, 2 ICs, 2 connectors, 2 switches, 2 diodes and 2 capacitors.

From the project

Example install command for ArchLinux, Manjaro, or any other Arch-based GNU/Linux distributions OS.

Example install command for ArchLinux, Manjaro, or any other Arch-based GNU/Linux distributions OS.

To install TeXLive package, you can use command:

It will download approximately 800MB and installation size about 2.5GB.

This should be reproducible in other GNU/Linux distributions like Ubuntu or Fedora.

For editor, you can choose TeXStudio and can be installed using command:

My latexbook, from the project README
From the project README

Main components on the My latexbook

ESP32-WROOM-32AMS1117-3.3

My latexbook bill of materials (BOM)

18 components, 14 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
ESP32-WROOM-32
U1
1
AMS1117-3.3
U2
1
Conn_01x03_Male
J1
1
Conn_01x02_Male
J2
1
R_Potentiometer_Trim
RV1
2
SW_Push
SW1, SW2
1
LED
D1
1
D
D2
1
100nF
C1
1
100uF
C2
2
0
R1, R2
3
10K
R3, R4, R7
1
220
R5
1
LDR03
R6

My latexbook design files

The KiCad project lives in the mekatronik-achmadi/my_latexbook repository on GitHub; these links point at the commit this page was built from.

My latexbook: common questions

What microcontroller does the My latexbook use?

The My latexbook is built around the ESP32-WROOM-32, from the ESP32 family.

How big is the My latexbook PCB?

The My latexbook measures 49.7 × 53.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the My latexbook?

18 components, from 14 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the My latexbook design files?

From the mekatronik-achmadi/my_latexbook repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the My latexbook design in my own project?

The repository has no license, so all rights stay with mekatronik-achmadi. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the My latexbook without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards