Module tester

mertwole·tetris·module_tester/module_tester.kicad_pcb

Module tester layout, top view — open source AVR/Arduino board by mertwole

About the Module tester

Module tester is an open source AVR/Arduino PCB design by mertwole, published on GitHub. It is a 2-layer board measuring 96.1 × 44.8 mm, with 18 components from 10 distinct parts.

Its main chip is the ATmega2560-16A, from the AVR/Arduino family. Other key parts include the 2EG03227-D2D-DF and CH340C. By type, the board carries 9 capacitors, 3 ICs, 3 resistors, 2 connectors and 1 crystal.

It belongs with the retro computing designs in this gallery.

From the project

NES tetris running on FPGA without processor

Main components on the Module tester

ATmega2560-16A2EG03227-D2D-DFCH340C

Module tester bill of materials (BOM)

18 components, 10 distinct parts.

QtyPartRefs
1
ATmega2560-16A
U1
1
2EG03227-D2D-DF
PCI-E X4
FOXCONN(富士康)
U2
1
CH340C
U3
1
16MHz
Y1
1
USB_C_Receptacle_USB2.0_16P
J1
1
USBASP
J2
7
100n
C1, C2, C3, C4, C5, C6, C9
2
22p
C7, C8
2
5.1k
R1, R2
1
12k
R3

Module tester design files

The KiCad project lives in the mertwole/tetris repository on GitHub; these links point at the commit this page was built from.

Module tester: common questions

What microcontroller does the Module tester use?

The Module tester is built around the ATmega2560-16A, from the AVR/Arduino family.

How big is the Module tester?

The Module tester measures 96.1 × 44.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Module tester?

18 components, from 10 distinct parts. The full bill of materials is listed on this page.

Where can I download the Module tester design files?

From the mertwole/tetris repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Module tester design in my own project?

The repository has no license, so all rights stay with mertwole. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Module tester without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in tetris

Similar boards