DSC Scan Selector

nanographs·Open-Beam-Interface·Hardware/PCBs/Interface selectors and drivers/DSC Scan Selector/DSC Scan Selector.kicad_pcb

DSC Scan Selector PCB layout, top view — open source board by nanographs

About the DSC Scan Selector PCB

DSC Scan Selector is an open source PCB design by nanographs, published on GitHub. It is a 4-layer board measuring 64 × 46.5 mm, with 5 components from 3 distinct parts.

By type, the board carries 2 diodes and 1 connector.

From the project

Just what you need to control the beam and get an image.

Just what you need to control the beam and get an image.

Glasgow makes getting bytes in and out of the FPGA over USB radically more accessible. We use that to make getting data into and out of your microscope radically more accessible.

- [X] Order and test rev 1 PCBs (Design not uploaded, required significant rework) - [X] Capture 16,384 x 16,384 images - [X] Live viewer fast enough to focus and stigmate with - [X] Raster pattern mode at 16,384 x 16,384 image resolution, with 8-bit grayscale dwell times - [X] Order and test V1.0 PCBs - [x] Refactor gateware to support 16-bit grayscale…

DSC Scan Selector bill of materials (BOM)

5 components, 3 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
M8_CONN_01X03_PIN_SHIELDED
M8_conn_01x03_Pin_Shielded
J4
2
Z5456
Omron G6K-2P-RF
RY1, RY2
2
1N4007
D1, D2

DSC Scan Selector design files

The KiCad project lives in the nanographs/Open-Beam-Interface repository on GitHub; these links point at the commit this page was built from.

DSC Scan Selector: common questions

How big is the DSC Scan Selector PCB?

The DSC Scan Selector measures 64 × 46.5 mm, has 4 copper layers and is 1.567 mm thick.

How many components are on the DSC Scan Selector?

5 components, from 3 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the DSC Scan Selector design files?

From the nanographs/Open-Beam-Interface repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the DSC Scan Selector design in my own project?

The repository has no license, so all rights stay with nanographs. Use it as a reference, and ask the author before reusing the design.

More boards in Open-Beam-Interface