HardLabs

Ch552-daplink vcut

Netetra·kicad-archive·project/robocon/ch552-daplink/ch552-daplink_vcut.kicad_pcb

Ch552-daplink vcut PCB layout, top view — open source WCH CH32/CH55x board by Netetra

About the Ch552-daplink vcut PCB

Ch552-daplink vcut is an open source WCH CH32/CH55x PCB design by Netetra, published on GitHub. It is a 2-layer board measuring 22 × 11.5 mm, with 21 components from 11 distinct parts.

Its main chip is the CH552E, from the WCH CH32/CH55x family. By type, the board carries 8 resistors, 6 test points, 2 connectors, 2 diodes, 2 capacitors and 1 IC.

Main components on the Ch552-daplink vcut

CH552E

Ch552-daplink vcut bill of materials (BOM)

21 components, 11 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
CH552E
U1
1
USB_C_RECEPTACLE_USB2.0_16P
USB_C_Receptacle_USB2.0_16P
J1
1
BOOT
J3
6
TestPoint
TP1, TP2, TP3, TP4, TP5, TP6
1
Blue
D1
1
Green
D2
2
0.1UF
0.1uF
C1, C2
2
5.1kΩ
R1, R2
2
1kΩ
R3, R4
1
10kΩ
R5
3
100Ω
R6, R7, R8

Ch552-daplink vcut design files

The KiCad project lives in the Netetra/kicad-archive repository on GitHub; these links point at the commit this page was built from.

Ch552-daplink vcut: common questions

What microcontroller does the Ch552-daplink vcut use?

The Ch552-daplink vcut is built around the CH552E, from the WCH CH32/CH55x family.

How big is the Ch552-daplink vcut PCB?

The Ch552-daplink vcut measures 22 × 11.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Ch552-daplink vcut?

21 components, from 11 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Ch552-daplink vcut design files?

From the Netetra/kicad-archive repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.

Can I use the Ch552-daplink vcut design in my own project?

The repository has no license, so all rights stay with Netetra. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Ch552-daplink vcut without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug WCH CH32/CH55x firmware against it before you order a PCB.

More boards in kicad-archive

Similar boards