Soft start

open-pe·soft-start

Soft start PCB layout, top view — open source board by open-pe

About the Soft start PCB

Soft start is an open source PCB design by open-pe, published on GitHub under the MIT license. It is a 2-layer board measuring 39.4 × 39.4 mm, with 17 components from 14 distinct parts.

Other key parts include the L78L15_TO92 and LM393. By type, the board carries 6 resistors, 3 capacitors, 2 ICs, 2 transistors, 1 connector and 1 diode.

It belongs with the power & battery designs in this gallery.

From the project

Soft-start to limit inrush and protect battery connectors

Simple soft start circuit with power MOSFET and NTC. It is designed to limit in-rush current of a DCDC converter connected to a battery with XT90i (like XT90 + 2 signal pins) connectors. The additional signal pin makes sure that the circuit resets after the connector is unplugged. Otherwise, it can be powered by the input capacitor of the load and doesn't "know" that the battery power is lost. Because battery voltage changes with battery SoC, absolute voltage at load input cannot tell wether the input capacitance is fully charged.

Main components on the Soft start

L78L15_TO92LM393

Soft start bill of materials (BOM)

17 components, 14 distinct parts.

QtyPartRefs
1
L78L15_TO92
U1
1
LM393
U2
1
IRF100B201
Q1
1
IRF100B201
Q2
1
Conn_01x02
J1
1
200k
RV1
1
10D-7
TH1
1
LED
D1
2
100n
C1, C3
1
0.47u
C2
1
2k
R1
2
10k
R2, R5
2
1k
R3, R4
1
1meg
R6

Soft start design files

The KiCad project lives in the open-pe/soft-start repository on GitHub; these links point at the commit this page was built from.

Soft start: common questions

How big is the Soft start PCB?

The Soft start measures 39.4 × 39.4 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Soft start?

17 components, from 14 distinct parts. The full bill of materials is listed on this page.

Where can I download the Soft start design files?

From the open-pe/soft-start repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Soft start design in my own project?

Yes, under the terms of its MIT license, which open-pe chose for the repository.

Similar boards