Quark uno

protoplasma-mx·quark_uno

Quark uno PCB layout, top view — open source AVR/Arduino board by protoplasma-mx

About the Quark uno PCB

Quark uno is an open source AVR/Arduino PCB design by protoplasma-mx, published on GitHub. It is a 2-layer board measuring 68.6 × 53.3 mm, with 48 components from 29 distinct parts.

Its main chip is the ATmega328-AU, from the AVR/Arduino family. Other key parts include the TLV1117-50, APE8865N-33-HF-3, LM393 and CH340G/C. By type, the board carries 14 capacitors, 8 connectors, 7 resistors, 5 ICs, 5 diodes and 2 crystals.

From the project

Una tarjeta compatible con Arduino Uno, diseñada y hecha en México

Main components on the Quark uno

Quark uno bill of materials (BOM)

48 components, 29 distinct parts.

QtyPartRefs
1
TLV1117-50
U1
1
APE8865N-33-HF-3
U2
1
LM393
U3
1
ATmega328-AU
U4
1
CH340G/C
U5
1
KIA3401
Q1
1
Crystal_GND3
Y1
1
16MHz
Y2
1
DC_IN
J1
1
ICSP
J2
1
Power
J3
1
D8-13
J5
1
I2C
J6
1
A0-5
J7
1
USB
J8
1
D0-7
J9
4
—
@HOLE0, @HOLE1, @HOLE2, @HOLE3
1
Polyfuse
F1
1
SW_Push
SW1
1
Verde
D1
Show 9 more
QtyPartRefs
1
D_Schottky
D2
2
Rojo
D3, D4
1
Azul
D5
2
100µ
C1, C2
7
100n
C3, C4, C5, C7, C8, C9, C10
1
100nF
C6
4
15p
C11, C12, C13, C14
4
1k
R1, R2, R3, R4
3
10k
R5, R6, R7

Quark uno design files

The KiCad project lives in the protoplasma-mx/quark_uno repository on GitHub; these links point at the commit this page was built from.

Quark uno: common questions

What microcontroller does the Quark uno use?

The Quark uno is built around the ATmega328-AU, from the AVR/Arduino family.

How big is the Quark uno PCB?

The Quark uno measures 68.6 × 53.3 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Quark uno?

48 components, from 29 distinct parts. The full bill of materials is listed on this page.

Where can I download the Quark uno design files?

From the protoplasma-mx/quark_uno repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Quark uno design in my own project?

The repository has no license, so all rights stay with protoplasma-mx. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Quark uno without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards