HardLabs

Keypad

PurkkaKoodari·ktane-hw·hardware/keypad/keypad.kicad_pcb

Keypad PCB layout, top view — open source AVR/Arduino board by PurkkaKoodari

About the Keypad PCB

Keypad is an open source AVR/Arduino PCB design by PurkkaKoodari, published on GitHub under the MIT license. It is a 2-layer board measuring 100 × 100 mm, with 26 components from 10 distinct parts.

Its main chip is the Arduino_Nano_v3.x, from the AVR/Arduino family. Other key parts include the WAVGAT_CAN. By type, the board carries 8 resistors, 7 diodes, 4 switches, 4 capacitors, 1 IC and 1 module.

From the project

Fully playable hardware implementation of Keep Talking and Nobody Explodes. Mirror of https://gitlab.com/PurkkaKoodari/ktane-hw

This project is a hardware reimplementation of the game [Keep Talking and Nobody Explodes][ktane]. The game runs fully on the physical device and is controlled using a web interface over Wi-Fi. The project will be documented in this repository – expect the links below to be broken for the near future.

The hardware is built around a Raspberry Pi Zero W, which runs the main controller software, attached to a backplane that provides power, connectivity and audio. The game's modules are built as independent devices, usually based on an Arduino Nano, which connect to the backplane using…

Main components on the Keypad

WAVGAT_CANArduino_Nano_v3.x

Keypad bill of materials (BOM)

26 components, 10 distinct parts.

QtyPartRefs
1
WAVGAT_CAN
U1
1
Arduino_Nano_v3.x
A1
1
RJ45_Shielded
J1
4
SW_Push
SW1, SW2, SW3, SW4
2
LED_Small
D1, D2
1
LED_RCGB
D3
4
LED
D4, D5, D6, D7
4
C
C1, C2, C3, C4
2
560R
R1, R2
6
220R
R3, R4, R5, R6, R7, R8

Keypad design files

The KiCad project lives in the PurkkaKoodari/ktane-hw repository on GitHub; these links point at the commit this page was built from.

Keypad: common questions

What microcontroller does the Keypad use?

The Keypad is built around the Arduino_Nano_v3.x, from the AVR/Arduino family.

How big is the Keypad PCB?

The Keypad measures 100 × 100 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Keypad?

26 components, from 10 distinct parts. The full bill of materials is listed on this page.

Where can I download the Keypad design files?

From the PurkkaKoodari/ktane-hw repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Keypad design in my own project?

Yes, under the terms of its MIT license, which PurkkaKoodari chose for the repository.

Can I test firmware for the Keypad without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in ktane-hw

Similar boards