HardLabs

FP2800A-Tester

Qeteshpony·FP2800A-Tester·pcb/FP2800A-Tester.kicad_pcb

FP2800A-Tester PCB layout, top view — open source AVR/Arduino board by Qeteshpony

About the FP2800A-Tester PCB

FP2800A-Tester is an open source AVR/Arduino PCB design by Qeteshpony, published on GitHub under the BSD-2-Clause license. It is a 2-layer board measuring 66 × 68.6 mm, with 89 components from 8 distinct parts.

Its main chip is the Arduino_UNO_R3, from the AVR/Arduino family. Other key parts include the FP2800A. By type, the board carries 56 diodes, 28 resistors, 1 IC, 1 module, 1 jumper and 1 switch.

It belongs with the dev boards & breakouts and displays & leds designs in this gallery.

From the project

Arduino Uno compatible shield for testing functionality of a FP2800A

FP2800A-Tester, from the project README
From the project README

Main components on the FP2800A-Tester

FP2800AArduino_UNO_R3

FP2800A-Tester bill of materials (BOM)

89 components, 8 distinct parts.

QtyPartRefs
1
FP2800A
U1
1
Arduino_UNO_R3
A1
1
COM
JP1
1
Reset
SW1
28
H
D1, D3, D5, D7, D9, D11, D13, D15 +20
28
L
D2, D4, D6, D8, D10, D12, D14, D16 +20
1
100nF
C1
28
1k5
R2, R3, R4, R5, R6, R7, R8, R9 +20

FP2800A-Tester design files

The KiCad project lives in the Qeteshpony/FP2800A-Tester repository on GitHub; these links point at the commit this page was built from.

FP2800A-Tester: common questions

What microcontroller does the FP2800A-Tester use?

The FP2800A-Tester is built around the Arduino_UNO_R3, from the AVR/Arduino family.

How big is the FP2800A-Tester PCB?

The FP2800A-Tester measures 66 × 68.6 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the FP2800A-Tester?

89 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the FP2800A-Tester design files?

From the Qeteshpony/FP2800A-Tester repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the FP2800A-Tester design in my own project?

Yes, under the terms of its BSD-2-Clause license, which Qeteshpony chose for the repository.

Can I test firmware for the FP2800A-Tester without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards