HardLabs

Ntm needle biopsy

redtrek·ntm_needle_biopsy·pcb/motor_biospy_needle/motor_biopsy_needle/motor_biopsy_needle.kicad_sch

This repository ships a schematic but no board layout.

About the Ntm needle biopsy PCB

Ntm needle biopsy is an open source AVR/Arduino PCB design by redtrek, published on GitHub. It is a board, with 5 components from 4 distinct parts.

Its main chip is the Arduino_UNO_R3, from the AVR/Arduino family. By type, the board carries 1 module, 1 switch and 1 resistor.

It belongs with the displays & leds and dev boards & breakouts designs in this gallery.

From the project

Nontraditional Manufacturing Laboratory - Needle Biopsy Device Code

https://redtrek.github.io/ntmneedlebiopsy/

OLED Display: - Supports input via a potentiometer and accurately displays in real time. - Shows current, RPM, position, and force information in real-time. - General status and battery capacity information.

Real-time Data Collection - Device can track and log position, current, RPM, and force information in real time. - Navigation of state machine through calculated sensor values. - Automated safety limits based on distance traveled by device. - Real-time low pass and moving average filter calculations and logging.

Main components on the Ntm needle biopsy

Arduino_UNO_R3

Ntm needle biopsy bill of materials (BOM)

5 components, 4 distinct parts.

QtyPartRefs
1
Arduino_UNO_R3
A1
1
SW_SPST
SW1
2
~
ina1, md31c1
1
10k
R1

Ntm needle biopsy design files

The KiCad project lives in the redtrek/ntm_needle_biopsy repository on GitHub; these links point at the commit this page was built from.

Ntm needle biopsy: common questions

What microcontroller does the Ntm needle biopsy use?

The Ntm needle biopsy is built around the Arduino_UNO_R3, from the AVR/Arduino family.

How many components are on the Ntm needle biopsy?

5 components, from 4 distinct parts. The full bill of materials is listed on this page.

Where can I download the Ntm needle biopsy design files?

From the redtrek/ntm_needle_biopsy repository on GitHub, which has the schematic; the links under Design files point to each one.

Can I use the Ntm needle biopsy design in my own project?

The repository has no license, so all rights stay with redtrek. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Ntm needle biopsy without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards