Pitch conversion substrate
ricelectric·pitch-conversion-substrate·kicad/pitch_conversion_substrate.kicad_pcb
About the Pitch conversion substrate PCB
Pitch conversion substrate is an open source ESP32 PCB design by ricelectric, published on GitHub under the MIT license. It is a 4-layer board measuring 22.9 × 46 mm, with 3 components from 2 distinct parts.
Its main chip is the ESP32-C3-WROOM-02, from the ESP32 family. By type, the board carries 2 connectors and 1 IC.
From the project
This is a very compact pitch conversion substrate for ESP32-C3.
This is an open source repository for a pitch conversion substrate for ESP32-C3. More information is available here.

Main components on the Pitch conversion substrate
Pitch conversion substrate bill of materials (BOM)
3 components, 2 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | ESP32-C3-WROOM-02 | ESP32-C3-WROOM-02 | U1 |
| 2 | CONN_01X09 Conn_01x09 | PinHeader_1x09_P2.54mm_Vertical | J1, J2 |
Pitch conversion substrate design files
The KiCad project lives in the ricelectric/pitch-conversion-substrate repository on GitHub; these links point at the commit this page was built from.
Pitch conversion substrate: common questions
What microcontroller does the Pitch conversion substrate use?
The Pitch conversion substrate is built around the ESP32-C3-WROOM-02, from the ESP32 family.
How big is the Pitch conversion substrate PCB?
The Pitch conversion substrate measures 22.9 × 46 mm, has 4 copper layers and is 4.69 mm thick.
How many components are on the Pitch conversion substrate?
3 components, from 2 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the Pitch conversion substrate design files?
From the ricelectric/pitch-conversion-substrate repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.
Can I use the Pitch conversion substrate design in my own project?
Yes, under the terms of its MIT license, which ricelectric chose for the repository.
Can I test firmware for the Pitch conversion substrate without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.
Similar boards
ESP32
OSO-BOOK-B1
joeycastillo
85 × 115 mm65 parts2LCC-BY-SA-4.08.1kESP32
Powertrain
byrantech
64 × 45.4 mm171 parts4LMIT4.3kESP32
Esp32 minimal
atopile
36.2 × 26.8 mm20 parts2LMIT4.0kESP32
Badge
atopile
56.3 × 39 mm239 parts4LMIT4.0kESP32
Racer
StuckAtPrototype
36 × 50.2 mm70 parts4LApache-2.03.8kESP32
Controller
StuckAtPrototype
29 × 74 mm58 parts4LApache-2.03.8k