Makermatrix

ril3y·makermatrix_hardware

Makermatrix PCB layout, top view — open source STM32 board by ril3y

About the Makermatrix PCB

Makermatrix is an open source STM32 PCB design by ril3y, published on GitHub. It is a 2-layer board measuring 13 × 50 mm, with 20 components from 16 distinct parts.

Its main chip is the STM32F030F4Px, from the STM32 family. Other key parts include the XC6206P332MR-MS. By type, the board carries 8 capacitors, 4 connectors, 3 ICs, 2 resistors, 1 fuse and 1 switch.

It belongs with the sensors designs in this gallery.

From the project

Hardware design files for MakerMatrix project

Files: - makermatrix.kicadsch - Main schematic - makermatrix.kicadpcb - PCB layout - hallinputs.kicadsch - Hall sensor input circuitry - schmaticreel.pdf - Schematic PDF export - pcbreel.pdf - PCB layout PDF export

Main components on the Makermatrix

STM32F030F4PxXC6206P332MR-MS

Makermatrix bill of materials (BOM)

20 components, 16 distinct parts.

QtyPartRefs
1
STM32F030F4Px
U1
1
~
U2
1
XC6206P332MR-MS
U4
1
OUT
J1
1
IN
J2
1
Conn_01x02_Pin
J3
1
5V
J5
1
4.7k
F1
1
4*4*1.7
SW1
1
LTST-C19HE1WT_C458749
LED1
1
10uF
C1
4
.1uF
C2, C3, C6, C8
2
CS2012X7R106M100NRE
C4, C7
1
4.7uF
C5
1
10k
RN1
1
22
RN2

Makermatrix design files

The KiCad project lives in the ril3y/makermatrix_hardware repository on GitHub; these links point at the commit this page was built from.

Makermatrix: common questions

What microcontroller does the Makermatrix use?

The Makermatrix is built around the STM32F030F4Px, from the STM32 family.

How big is the Makermatrix PCB?

The Makermatrix measures 13 × 50 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Makermatrix?

20 components, from 16 distinct parts. The full bill of materials is listed on this page.

Where can I download the Makermatrix design files?

From the ril3y/makermatrix_hardware repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Makermatrix design in my own project?

The repository has no license, so all rights stay with ril3y. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Makermatrix without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

More boards in makermatrix_hardware

Similar boards