HardLabs

InfinitiMirror

RT-CUSTOMZ·InfinityMirror·PCB/InfinitiMirror.kicad_pcb

InfinitiMirror PCB layout, top view — open source ESP8266 board by RT-CUSTOMZ

About the InfinitiMirror PCB

InfinitiMirror is an open source ESP8266 PCB design by RT-CUSTOMZ, published on GitHub under the CC0-1.0 license. It is a 2-layer board measuring 30 × 45 mm, with 16 components from 11 distinct parts.

Its main chip is the ESP-12F, from the ESP8266 family. By type, the board carries 5 capacitors, 5 resistors, 1 transistor and 1 diode.

From the project

A small inifinity mirror using WLED on an ESP8266

InfinitiMirror bill of materials (BOM)

16 components, 11 distinct parts.

QtyPartRefs
1
FDN340P
Q1
1
5V_In
5V_IN
1
5V
5V_OUT
1
ESP-12F
ESP8266
1
LT1117-3.3
LM1337
1
BZT52C6V8
D1
2
100nF
C1, C3
2
10u
C2, C4
1
330u
C5
4
10k
R1, R2, R3, R4
1
100k
R5

InfinitiMirror design files

The KiCad project lives in the RT-CUSTOMZ/InfinityMirror repository on GitHub; these links point at the commit this page was built from.

InfinitiMirror: common questions

What microcontroller does the InfinitiMirror use?

The InfinitiMirror is built around the ESP-12F, from the ESP8266 family.

How big is the InfinitiMirror PCB?

The InfinitiMirror measures 30 × 45 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the InfinitiMirror?

16 components, from 11 distinct parts. The full bill of materials is listed on this page.

Where can I download the InfinitiMirror design files?

From the RT-CUSTOMZ/InfinityMirror repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the InfinitiMirror design in my own project?

Yes, under the terms of its CC0-1.0 license, which RT-CUSTOMZ chose for the repository.

Can I test firmware for the InfinitiMirror without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP8266 firmware against it before you order a PCB.

More boards in InfinityMirror

Similar boards