HardLabs

AQUADAPT Multiparametric Probe

samuel-q-fernandes·AQUADAPT_Multiparametric_Probe·Hardware/Board PCB/Board V1.0/Board V1.0.kicad_pcb

AQUADAPT Multiparametric Probe PCB layout, top view — open source board by samuel-q-fernandes

About the AQUADAPT Multiparametric Probe PCB

AQUADAPT Multiparametric Probe is an open source PCB design by samuel-q-fernandes, published on GitHub under the MIT license. It is a 2-layer board measuring 99.1 × 99.1 mm, with 9 components from 9 distinct parts.

Other key parts include the TTGO-TCALL-SIM800. By type, the board carries 6 connectors, 1 IC and 1 resistor.

It belongs with the power & battery and sensors designs in this gallery.

From the project

AQUADAPT | AQUA-V1 is an open-source platform for in-situ water-quality/quantity monitoring (pH, electrical conductivity (EC), temperature, and water level). The system targets robust, long-term field deployments with an emphasis on reproducibility, traceability, and low total co

AQUADAPT | AQUA-V1 is an open-source platform for in-situ water-quality/quantity monitoring (pH, electrical conductivity (EC), temperature, and water level). The system targets robust, long-term field deployments with an emphasis on reproducibility, traceability, and low total cost.

The hardware integrates an ESP32 controller (LILYGO® T-Call with SIM800L) for data acquisition and processing, plus GSM/GPRS telemetry, microSD logging, and solar power support (MPPT + Li-ion). Firmware duty-cycles sensing and transmission, then enters deep sleep between cycles to minimize average power…

Main components on the AQUADAPT Multiparametric Probe

TTGO-TCALL-SIM800

AQUADAPT Multiparametric Probe bill of materials (BOM)

9 components, 9 distinct parts.

QtyPartRefs
1
TTGO-TCALL-SIM800
U1
1
MicroSD Card
J1
1
pH Sensor
J2
1
Cond. Sensor
J3
1
Temperature Sensor JST
J4
1
Level Sensor
J5
1
Level Sensor Energy JST
J6
1
~
MT3608_Module1
1
4.7k
R1

AQUADAPT Multiparametric Probe design files

The KiCad project lives in the samuel-q-fernandes/AQUADAPT_Multiparametric_Probe repository on GitHub; these links point at the commit this page was built from.

AQUADAPT Multiparametric Probe: common questions

How big is the AQUADAPT Multiparametric Probe PCB?

The AQUADAPT Multiparametric Probe measures 99.1 × 99.1 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the AQUADAPT Multiparametric Probe?

9 components, from 9 distinct parts. The full bill of materials is listed on this page.

Where can I download the AQUADAPT Multiparametric Probe design files?

From the samuel-q-fernandes/AQUADAPT_Multiparametric_Probe repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the AQUADAPT Multiparametric Probe design in my own project?

Yes, under the terms of its MIT license, which samuel-q-fernandes chose for the repository.

Similar boards