Piano-Sampler

Shashvat1333·Piano-Sampler

Piano-Sampler

About the Piano-Sampler PCB

Piano-Sampler is an open source ESP32 PCB design by Shashvat1333, published on GitHub under the MIT license. It is a board, with 17 components from 4 distinct parts.

Its main chip is the ESP32-WROOM-32, from the ESP32 family. By type, the board carries 4 switches, 1 IC and 1 resistor.

It belongs with the audio and test & measurement designs in this gallery.

From the project

A DIY piano sampler is a homemade instrument built with a microcontroller. It records your audio, saves it, and lets you play it back with piano keys while tweaking playback speed, pitch, and instrument sounds!

A standalone sampler built with an ESP32. Touch a pad and it plays a sound from an SD card.

- 7 touch pads: Touch a pad to play a sound. - 5 instrument presets: Acoustic Piano, Banjo, Guitar, Percussion, and Saxophone. - Record and play: Record your own audio and play it back. - Volume knob and LCD: Adjust the volume and see the current preset.

Enclosure designed in Onshape: View Onshape Model

Main components on the Piano-Sampler

Piano-Sampler bill of materials (BOM)

17 components, 4 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
ESP32-WROOM-32
U1
11
—
8ohm-Speaker1, I2C-1, MAX98357, MIcro-SD-Module1, TTP1, TTP2, TTP3, TTP4 +3
4
SW_Push
SW1, SW2, SW3, SW4
1
Potentiometer
R1

Piano-Sampler design files

The KiCad project lives in the Shashvat1333/Piano-Sampler repository on GitHub; these links point at the commit this page was built from.

Piano-Sampler: common questions

What microcontroller does the Piano-Sampler use?

The Piano-Sampler is built around the ESP32-WROOM-32, from the ESP32 family.

How many components are on the Piano-Sampler?

17 components, from 4 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Piano-Sampler design files?

From the Shashvat1333/Piano-Sampler repository on GitHub, which has the schematic and the BOM; the links under Design files point to each one.

Can I use the Piano-Sampler design in my own project?

Yes, under the terms of its MIT license, which Shashvat1333 chose for the repository.

Can I test firmware for the Piano-Sampler without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards