ATTINY

shreejita56·ATTINY·PCB/ATTiny1616-S.kicad_pcb

ATTINY PCB layout, top view — open source AVR/Arduino board by shreejita56

About the ATTINY PCB

ATTINY is an open source AVR/Arduino PCB design by shreejita56, published on GitHub. It is a 2-layer board measuring 21.7 × 29.8 mm, with 15 components from 11 distinct parts.

Its main chip is the ATtiny1616-S, from the AVR/Arduino family. Other key parts include the XC6206PxxxMR and CH340X. By type, the board carries 5 capacitors, 4 resistors, 3 ICs, 2 connectors and 1 diode.

It belongs with the usb & debug tools designs in this gallery.

From the project

I made a small devboard based on Atinny1616-S .It has inbuild 3.3V voltage regulator and a USB-to-UART serial convertor .Power and data comes from USB-C . The board has an inbuilt LED. and has 8 pin outlet in which 1 is gnd, 1 is power and another 6 are general out pin pins conne

I made a small devboard based on Atinny1616-S .It has inbuild 3.3V voltage regulator and a USB-to-UART serial convertor .Power and data comes from USB-C . The board has an inbuilt LED. and has 8 pin outlet in which 1 is gnd, 1 is power and another 6 are general out pin pins connected to the MCU. The Devboard was designed on kicad .

ATTINY, from the project README
From the project README

Main components on the ATTINY

ATTINY bill of materials (BOM)

15 components, 11 distinct parts.

QtyPartRefs
1
XC6206PxxxMR
U1
1
ATtiny1616-S
U2
1
CH340X
U3
1
USB_C_Receptacle_USB2.0_16P
J1
1
Conn_01x08_Pin
J10
1
LED
D1
3
1uF
C1, C2, C4
1
100nF
C3
1
0.1uF
C5
2
5.1k
R1, R2
2
1k
R3, R4

ATTINY design files

The KiCad project lives in the shreejita56/ATTINY repository on GitHub; these links point at the commit this page was built from.

ATTINY: common questions

What microcontroller does the ATTINY use?

The ATTINY is built around the ATtiny1616-S, from the AVR/Arduino family.

How big is the ATTINY PCB?

The ATTINY measures 21.7 × 29.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the ATTINY?

15 components, from 11 distinct parts. The full bill of materials is listed on this page.

Where can I download the ATTINY design files?

From the shreejita56/ATTINY repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the ATTINY design in my own project?

The repository has no license, so all rights stay with shreejita56. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the ATTINY without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards