HardLabs

How to-Make a-Guitar-Pedal

skngh·How-to-Make-a-Guitar-Pedal·hardware/chorus_pedal/chorus_pedal.kicad_pcb

How to-Make a-Guitar-Pedal PCB layout, top view — open source board by skngh
Simulate this board

About the How to-Make a-Guitar-Pedal PCB

How to-Make a-Guitar-Pedal is an open source PCB design by skngh, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 60 × 47 mm, with 11 components from 8 distinct parts.

Other key parts include the Electrosmith_Daisy_Seed_Rev4. By type, the board carries 1 module, 1 connector, 1 switch, 1 diode, 1 capacitor and 1 resistor.

It belongs with the audio designs in this gallery.

From the project

Documentation and example files for my YouTube course on designing and building a digital guitar pedal with the Daisy Seed.

This folder contains all hardware-related files used throughout the course, including the PCB design, enclosure artwork, and drill schematic.

The KiCad project files for the custom PCB designed during the course can be found in this folder.

- Open the KiCad project to view the schematic and PCB layout. - These files correspond to this code here.

The enclosure artwork used for UV printing is provided as an Adobe Illustrator file.

Main components on the How to-Make a-Guitar-Pedal

Electrosmith_Daisy_Seed_Rev4

How to-Make a-Guitar-Pedal bill of materials (BOM)

11 components, 8 distinct parts.

QtyPartRefs
1
Electrosmith_Daisy_Seed_Rev4
A1
1
Jack-DC
J3
2
AudioJack2
IN1, OUT1
3
R_Potentiometer
RV1, RV2, RV3
1
SW_SPST
SW1
1
LED
D1
1
C_Polarized
C1
1
1K
R1

How to-Make a-Guitar-Pedal design files

The KiCad project lives in the skngh/How-to-Make-a-Guitar-Pedal repository on GitHub; these links point at the commit this page was built from.

How to-Make a-Guitar-Pedal: common questions

How big is the How to-Make a-Guitar-Pedal PCB?

The How to-Make a-Guitar-Pedal measures 60 × 47 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the How to-Make a-Guitar-Pedal?

11 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the How to-Make a-Guitar-Pedal design files?

From the skngh/How-to-Make-a-Guitar-Pedal repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the How to-Make a-Guitar-Pedal design in my own project?

Yes, under the terms of its GPL-3.0 license, which skngh chose for the repository.

Similar boards