Hall effect sensor analog
About the Hall effect sensor analog PCB
Hall effect sensor analog is an open source PCB design by SolderedElectronics, published on GitHub under the TAPR-OHL-1.0 license. It is a 2-layer board measuring 22 × 22 mm, with 5 components from 4 distinct parts.
Other key parts include the SI7211-B-00-IV. By type, the board carries 1 IC, 1 relay and 1 capacitor.
It belongs with the sensors and dev boards & breakouts designs in this gallery.
From the project
Hardware design, BOM, gerbers and 3D files for Hall-effect-sensor-breakout-with-analog-output designed by Soldered Electronics.
The hall effect sensor (Hall Effect sensor) will be able to detect the magnetic field in its vicinity thanks to the aforementioned physical law. A magnetic field that can be created by a magnet, a current flowing through a conductor or some third source, the Hall effect sensor will recognize each. The stronger the magnetic field, the higher the voltage will be at the output of this sensor, so it is a sensor with analog output.
Main components on the Hall effect sensor analog
Hall effect sensor analog bill of materials (BOM)
5 components, 4 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | SI7211-B-00-IV | SOT-23-3 | U1 |
| 2 | HOLE_3.2mm | HOLE_3.2mm | H1, H2 |
| 1 | HEADER_MALE_3X1 | HEADER_MALE_3X1 | K1 |
| 1 | 0.1uF | 0603C | C1 |
Hall effect sensor analog design files
The KiCad project lives in the SolderedElectronics/Hall-effect-sensor-breakout-with-analog-output-hardware-design repository on GitHub; these links point at the commit this page was built from.
Hall effect sensor analog: common questions
How big is the Hall effect sensor analog PCB?
The Hall effect sensor analog measures 22 × 22 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Hall effect sensor analog?
5 components, from 4 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the Hall effect sensor analog design files?
From the SolderedElectronics/Hall-effect-sensor-breakout-with-analog-output-hardware-design repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.
Can I use the Hall effect sensor analog design in my own project?
Yes, under the terms of its TAPR-OHL-1.0 license, which SolderedElectronics chose for the repository.
More boards in Hall-effect-sensor-breakout-with-analog-output-hardware-design
Similar boards
Sensor smd
scottbez1
40 × 20 mm5 parts2LApache-2.04.2k
Sensors
StuckAtPrototype
15.2 × 9 mm14 parts4LApache-2.03.8k
Microphone
Mentra-Community
5.5 × 6.1 mm6 parts2LMIT1.2k
Eecv breakout
rusefi
140.8 × 53.7 mm9 parts4LGPL-3.01.2k
134pin 7-967288-1
139.7 × 73.7 mm38 parts2LGPL-3.01.2k
Breakout 60pin EEC-IV
139.7 × 62.2 mm15 parts2LGPL-3.01.2k