Alarmclock
supersoimon·alarmclock·PCB/Alarm Clock.kicad_pcb
About the Alarmclock PCB
Alarmclock is an open source ESP32 PCB design by supersoimon, published on GitHub. It is a 2-layer board measuring 184 × 58 mm, with 9 components from 4 distinct parts.
Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. By type, the board carries 6 switches, 1 IC, 1 connector and 1 buzzer.
It belongs with the keyboards designs in this gallery.
Main components on the Alarmclock
Alarmclock bill of materials (BOM)
9 components, 4 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | XIAO-ESP32-C3-SMD | XIAO-ESP32-C3-DIP | U1 |
| 1 | Conn_01x08_Pin | PinSocket_1x08_P2.54mm_Vertical | J1 |
| 1 | Buzzer | Buzzer_12x9.5RM7.6 | BZ1 |
| 6 | SW_Push | SW_Cherry_MX_1.00u_PCB | SW1, SW2, SW3, SW4, SW5, SW6 |
Alarmclock design files
The KiCad project lives in the supersoimon/alarmclock repository on GitHub; these links point at the commit this page was built from.
- LayoutPCB/Alarm Clock.kicad_pcb
- SchematicPCB/Alarm Clock.kicad_sch
- BOMBOM.csv
Alarmclock: common questions
What microcontroller does the Alarmclock use?
The Alarmclock is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.
How big is the Alarmclock PCB?
The Alarmclock measures 184 × 58 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Alarmclock?
9 components, from 4 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the Alarmclock design files?
From the supersoimon/alarmclock repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.
Can I use the Alarmclock design in my own project?
The repository has no license, so all rights stay with supersoimon. Use it as a reference, and ask the author before reusing the design.
Can I test firmware for the Alarmclock without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.
Similar boards
ESP32
OSO-BOOK-B1
joeycastillo
85 × 115 mm65 parts2LCC-BY-SA-4.08.1kESP32
Powertrain
byrantech
64 × 45.4 mm171 parts4LMIT4.3kESP32
Esp32 minimal
atopile
36.2 × 26.8 mm20 parts2LMIT4.0kESP32
Badge
atopile
56.3 × 39 mm239 parts4LMIT4.0kESP32
Racer
StuckAtPrototype
36 × 50.2 mm70 parts4LApache-2.03.8kESP32
Controller
StuckAtPrototype
29 × 74 mm58 parts4LApache-2.03.8k