CLOCK-IN

SyedIhteshamuddin·cLOCK-IN·PCB/cLOCK-IN Project.kicad_pcb

CLOCK-IN PCB layout, top view — open source ESP32 board by SyedIhteshamuddin

About the CLOCK-IN PCB

CLOCK-IN is an open source ESP32 PCB design by SyedIhteshamuddin, published on GitHub. It is a 2-layer board measuring 57 × 71.5 mm, with 7 components from 4 distinct parts.

Its main chip is the XIAO-ESP32-C3-SMD, from the ESP32 family. By type, the board carries 4 switches, 1 IC, 1 connector and 1 buzzer.

It belongs with the iot & wireless designs in this gallery.

From the project

A custom 4-key Alarm Clock to LOCK-IN!

A 4-key alarm clock built on a Seeed XIAO ESP32-C3 with a 284x76 ST7789 display and a buzzer. An alarm clock to wake you up to LOCK-IN!!

Schematic was the easiest thing to do in this entire project, i had done it under an hour!

I have manually routed the PCB. The PCB has 0 errors (DRC) except silkscreen warnings.

I'm new to CAD Designing So, it was not easy for me. I have designed this case in Onshape. This design is a "SANDWITCH STYLE AlARM-CLOCK" where it consists of two plates; Top plate, Bottom Case and PCB gets sandwiched between them. They are all screwed up with M3 Screws. All the…

CLOCK-IN, from the project README
From the project README

Main components on the CLOCK-IN

CLOCK-IN bill of materials (BOM)

7 components, 4 distinct parts.

QtyPartRefs
1
XIAO-ESP32-C3-SMD
U1
1
Conn_01x08_Pin
J1
1
Buzzer
BZ1
4
SW_Push
SW1, SW2, SW3, SW4

CLOCK-IN design files

The KiCad project lives in the SyedIhteshamuddin/cLOCK-IN repository on GitHub; these links point at the commit this page was built from.

CLOCK-IN: common questions

What microcontroller does the CLOCK-IN use?

The CLOCK-IN is built around the XIAO-ESP32-C3-SMD, from the ESP32 family.

How big is the CLOCK-IN PCB?

The CLOCK-IN measures 57 × 71.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the CLOCK-IN?

7 components, from 4 distinct parts. The full bill of materials is listed on this page.

Where can I download the CLOCK-IN design files?

From the SyedIhteshamuddin/cLOCK-IN repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the CLOCK-IN design in my own project?

The repository has no license, so all rights stay with SyedIhteshamuddin. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the CLOCK-IN without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards