Assignment 3 h bridge

TefoAM·MotorDriver-PiHat-Project·PiHAT files KiKad/H-Bridge Circuit files/assignment 3 h_bridge.kicad_pcb

Assignment 3 h bridge PCB layout, top view — open source board by TefoAM

About the Assignment 3 h bridge PCB

Assignment 3 h bridge is an open source PCB design by TefoAM, published on GitHub under the GPL-3.0 license. It is a 4-layer board measuring 40.6 × 24.1 mm, with 15 components from 6 distinct parts.

By type, the board carries 5 battery holders, 4 transistors, 4 resistors and 2 connectors.

It belongs with the robotics & motion and dev boards & breakouts designs in this gallery.

From the project

This repo contains files a Raspberry Pi Hat I designed. All the files made using LT Spice and Kicad, with which simulations to test the behaviors of the individual circuits were performed.

The PiHAT is a hardware board attached to a Raspberry Pi microcontroller. it is used to drive a motor using an external power source.

- boost convertor.asc - foldbackcircuit.asc - main power circuit.asc - zener.cir - H-Bridge circuit.asc - LED Circuit.asc

This repository contains all the files made using LT Spice and Kicad with which simulations to test the behaviors of the individual circuits were performed.

Assignment 3 h bridge bill of materials (BOM)

15 components, 6 distinct parts.

QtyPartRefs
4
2N2219
Q1, Q2, Q3, Q4
1
Motor_input_2
J1
1
Motor_input _2
J2
4
3 v
BT1, BT2, BT4, BT5
1
12 v
BT3
4
407
R1, R2, R3, R4

Assignment 3 h bridge design files

The KiCad project lives in the TefoAM/MotorDriver-PiHat-Project repository on GitHub; these links point at the commit this page was built from.

Assignment 3 h bridge: common questions

How big is the Assignment 3 h bridge PCB?

The Assignment 3 h bridge measures 40.6 × 24.1 mm, has 4 copper layers and is 1.6 mm thick.

How many components are on the Assignment 3 h bridge?

15 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the Assignment 3 h bridge design files?

From the TefoAM/MotorDriver-PiHat-Project repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Assignment 3 h bridge design in my own project?

Yes, under the terms of its GPL-3.0 license, which TefoAM chose for the repository.

More boards in MotorDriver-PiHat-Project

Similar boards