Sensor breakout

thewriterben·OpenCircuitCore·boards/sensor-breakout/sensor-breakout.kicad_pcb

Sensor breakout layout, top view — open source board by thewriterben

About the Sensor breakout

Sensor breakout is an open source PCB design by thewriterben, published on GitHub under the Apache-2.0 license. It is a 2-layer board measuring 22 × 26 mm, with 4 components from 3 distinct parts.

Other key parts include the BME280. By type, the board carries 2 resistors, 1 IC and 1 capacitor.

It belongs with the sensors and dev boards & breakouts designs in this gallery.

From the project

Electronics engine: circuits as atopile code, verified and emitted through KiCad

A BME280 I2C breakout, and the first board here whose connectivity comes from its schematic rather than being asserted alongside it.

reference-esp32s3 proved the toolchain, but its schematic and board were generated independently — nothing tied them together, so nothing stopped them disagreeing. This board is generated from makereferenceschematic.PARTS (the same single source of truth as the schematic) and its pads are bound to nets read out of the schematic's exported netlist.

Main components on the Sensor breakout

Sensor breakout bill of materials (BOM)

4 components, 3 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
BME280
U2
1
100n
C1
2
4.7k
R1, R2

Sensor breakout design files

The KiCad project lives in the thewriterben/OpenCircuitCore repository on GitHub; these links point at the commit this page was built from.

Sensor breakout: common questions

How big is the Sensor breakout?

The Sensor breakout measures 22 × 26 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Sensor breakout?

4 components, from 3 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Sensor breakout design files?

From the thewriterben/OpenCircuitCore repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.

Can I use the Sensor breakout design in my own project?

Yes, under the terms of its Apache-2.0 license, which thewriterben chose for the repository.

Similar boards