FlappyBird PIC18F4550

Thomas-GAUTRON·FlappyBird_PIC18F4550·Kicad/FlappyBird_Project.kicad_pcb

FlappyBird PIC18F4550 PCB layout, top view — open source PIC board by Thomas-GAUTRON

About the FlappyBird PIC18F4550 PCB

FlappyBird PIC18F4550 is an open source PIC PCB design by Thomas-GAUTRON, published on GitHub. It is a 2-layer board measuring 76.2 × 63.5 mm, with 14 components from 12 distinct parts.

Its main chip is the PIC18F4550-IP, from the PIC family. Other key parts include the M24C02-WMN. By type, the board carries 6 resistors, 2 ICs, 1 transistor, 1 crystal, 1 connector and 1 buzzer.

Main components on the FlappyBird PIC18F4550

FlappyBird PIC18F4550 bill of materials (BOM)

14 components, 12 distinct parts.

QtyPartRefs
1
PIC18F4550-IP
U1
1
M24C02-WMN
U2
1
BC846
Q2
1
Crystal_GND3
Y1
1
USB_B
J1
1
Buzzer
BZ1
1
SW_Omron_B3FS
SW1
1
LED
D1
1
4K7
R1
1
10K
R2
3
1K
R3, R5, R6
1
220
R4

FlappyBird PIC18F4550 design files

The KiCad project lives in the Thomas-GAUTRON/FlappyBird_PIC18F4550 repository on GitHub; these links point at the commit this page was built from.

FlappyBird PIC18F4550: common questions

What microcontroller does the FlappyBird PIC18F4550 use?

The FlappyBird PIC18F4550 is built around the PIC18F4550-IP, from the PIC family.

How big is the FlappyBird PIC18F4550 PCB?

The FlappyBird PIC18F4550 measures 76.2 × 63.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the FlappyBird PIC18F4550?

14 components, from 12 distinct parts. The full bill of materials is listed on this page.

Where can I download the FlappyBird PIC18F4550 design files?

From the Thomas-GAUTRON/FlappyBird_PIC18F4550 repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the FlappyBird PIC18F4550 design in my own project?

The repository has no license, so all rights stay with Thomas-GAUTRON. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the FlappyBird PIC18F4550 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug PIC firmware against it before you order a PCB.

Similar boards