Segno led strip
tomassasovsky·segno-hardware·hardware/led_strip/out/segno_led_strip.kicad_pcb
About the Segno led strip PCB
Segno led strip is an open source PCB design by tomassasovsky, published on GitHub under the CERN-OHL-S-2.0 license. It is a 2-layer board measuring 16 × 8 mm, with 4 components from 3 distinct parts.
By type, the board carries 2 connectors, 1 diode and 1 capacitor.
From the project
Segno hardware: boards, sheet-metal enclosure, printed parts and decals
Single-LED WS2812B indicator puck for the Segno console: one board per indicator pedal, sitting under that pedal's small pill diffuser slot in the faceplate. One board is 16 x 8 mm, 2-layer, 1.6 mm, carrying 1x WS2812B 5050 addressable LED (with its 100nF 0603 decoupling cap) and castellated half-hole pads on both 8 mm ends.
Boards daisy-chain pedal to pedal with three short wires (5V / DATA / GND, same pad order top-to-bottom on both ends — left-end DATA is DIN, right-end DATA is DOUT) soldered to the castellated end pads. The castellations also allow butting boards edge-to-edge (the LED…
Segno led strip bill of materials (BOM)
4 components, 3 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 2 | castellated_edge | J1, J2 | |
| 1 | LED_WS2812B_PLCC4_5.0x5.0mm_P3.2mm | LED_WS2812B_PLCC4_5.0x5.0mm_P3.2mm | D1 |
| 1 | K104K10X7RF53H5 C_0603_1608Metric | C_0603_1608Metric | C1 |
Segno led strip design files
The KiCad project lives in the tomassasovsky/segno-hardware repository on GitHub; these links point at the commit this page was built from.
Segno led strip: common questions
How big is the Segno led strip PCB?
The Segno led strip measures 16 × 8 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Segno led strip?
4 components, from 3 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the Segno led strip design files?
From the tomassasovsky/segno-hardware repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.
Can I use the Segno led strip design in my own project?
Yes, under the terms of its CERN-OHL-S-2.0 license, which tomassasovsky chose for the repository.
More boards in segno-hardware
Raspberry Pi
Segno console board
tomassasovsky
99.5 × 99.5 mm77 parts2LCERN-OHL-S-2.00Raspberry Pi
Console.placed
tomassasovsky
99.5 × 99.5 mm77 parts2LCERN-OHL-S-2.00Screen power hand
tomassasovsky
68 × 76 mm42 parts2LCERN-OHL-S-2.00Screen power hand.placed
tomassasovsky
68 × 76 mm42 parts2LCERN-OHL-S-2.00RP2040/RP2350
Segno pedal ring
tomassasovsky
80 × 80 mm18 parts2LCERN-OHL-S-2.00