35keypad

tommasogualtierotti·35keypad·v1/35keypad.kicad_pcb

35keypad PCB layout, top view — open source RP2040/RP2350 board by tommasogualtierotti

About the 35keypad PCB

35keypad is an open source RP2040/RP2350 PCB design by tommasogualtierotti, published on GitHub under the CC0-1.0 license. It is a 2-layer board measuring 143.4 × 105.4 mm, with 65 components from 15 distinct parts.

Its main chip is the RP2040, from the RP2040/RP2350 family. Other key parts include the W25Q128JVS and NCP1117-3.3_SOT223. By type, the board carries 35 diodes, 16 capacitors, 7 resistors, 3 ICs, 2 switches and 1 crystal.

It belongs with the keyboards designs in this gallery.

From the project

35 keys programmable Macropad based on RP2040 MCU from Raspberry Pi, running KMK firmware

35keypad, from the project README
From the project README

Main components on the 35keypad

35keypad bill of materials (BOM)

65 components, 15 distinct parts.

QtyPartRefs
1
W25Q128JVS
U1
1
RP2040
U2
1
NCP1117-3.3_SOT223
U3
1
12MHz
Y1
1
USB_C_Receptacle_USB2.0
J1
2
SW_SPST
SW1, SW2
35
D
D1, D2, D3, D4, D5, D6, D7, D8 +27
10
100n
C1, C3, C4, C6, C7, C9, C10, C13 +2
4
1u
C2, C5, C8, C11
2
30p
C12, C15
1
10k
R1
2
5k1
R2, R3
1
DNP_10k
R4
1
1k
R5
2
27
R6, R7

35keypad design files

The KiCad project lives in the tommasogualtierotti/35keypad repository on GitHub; these links point at the commit this page was built from.

35keypad: common questions

What microcontroller does the 35keypad use?

The 35keypad is built around the RP2040, from the RP2040/RP2350 family.

How big is the 35keypad PCB?

The 35keypad measures 143.4 × 105.4 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the 35keypad?

65 components, from 15 distinct parts. The full bill of materials is listed on this page.

Where can I download the 35keypad design files?

From the tommasogualtierotti/35keypad repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the 35keypad design in my own project?

Yes, under the terms of its CC0-1.0 license, which tommasogualtierotti chose for the repository.

Can I test firmware for the 35keypad without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

Similar boards