PicoDeck
tronicbaumi·PicoDeck·hw/PicoDeck/PicoDeck.kicad_pcb
About the PicoDeck PCB
PicoDeck is an open source AVR/Arduino PCB design by tronicbaumi, published on GitHub under the BSD-3-Clause license. It is a 2-layer board measuring 19.3 × 12.8 mm, with 2 components from 2 distinct parts.
Its main chip is the Arduino_Pro_Mini, from the AVR/Arduino family. Other key parts include the Clone_Pro_Mini_Socket_NoSPH.
It belongs with the displays & leds designs in this gallery.
From the project
physical userinterface for Picoscope 7 software to improve user experience
A small USB control panel for PicoScope 7, built around an Arduino Micro (ATmega32u4). It enumerates as a USB HID keyboard and turns two rotary encoders and four push buttons into the keyboard shortcuts PicoScope uses for amplitude, offset, filter, time base, trigger and pre-trigger. A 0.96" 128x64 OLED shows the active channel and the current encoder modes.
Main components on the PicoDeck
PicoDeck bill of materials (BOM)
2 components, 2 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | Arduino_Pro_Mini | Arduino_pro_mini | A1 |
| 1 | Clone_Pro_Mini_Socket_NoSPH | Clone_Pro_Mini_Socket_NoSPH | A2 |
PicoDeck design files
The KiCad project lives in the tronicbaumi/PicoDeck repository on GitHub; these links point at the commit this page was built from.
- Layouthw/PicoDeck/PicoDeck.kicad_pcb
- Schematichw/PicoDeck/PicoDeck.kicad_sch
PicoDeck: common questions
What microcontroller does the PicoDeck use?
The PicoDeck is built around the Arduino_Pro_Mini, from the AVR/Arduino family.
How big is the PicoDeck PCB?
The PicoDeck measures 19.3 × 12.8 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the PicoDeck?
2 components, from 2 distinct parts. The full bill of materials is listed on this page.
Where can I download the PicoDeck design files?
From the tronicbaumi/PicoDeck repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.
Can I use the PicoDeck design in my own project?
Yes, under the terms of its BSD-3-Clause license, which tronicbaumi chose for the repository.
Can I test firmware for the PicoDeck without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.
Similar boards
AVR/Arduino
Magspoof
samyk
35 × 29 mm11 parts2LNo license4.2kAVR/Arduino
Redox keyboard
mattdibi
162.2 × 126.5 mm77 parts2LMIT2.0kAVR/Arduino
Labrador
espotek-org
36.8 × 34.7 mm75 parts2LNo license1.2kAVR/Arduino
ModuleV450
stuartpittaway
30 × 61.4 mm39 parts2LCC-BY-NC-4.01.1kAVR/Arduino
V4
stuartpittaway
30 × 50 mm38 parts2LCC-BY-NC-4.01.1kAVR/Arduino
Discipline
coseyfannitutti
304.9 × 122.8 mm170 parts2LCC-BY-NC-4.01.0k