Mover

tuxy·mover·mover_pcb/mover-pcb.kicad_pcb

Mover PCB layout, top view — open source RP2040/RP2350 board by tuxy

About the Mover PCB

Mover is an open source RP2040/RP2350 PCB design by tuxy, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 46.5 × 62.5 mm, with 8 components from 7 distinct parts.

Its main chip is the RaspberryPi_Pico, from the RP2040/RP2350 family. Other key parts include the TB6612FNG. By type, the board carries 4 connectors, 1 IC, 1 module, 1 transistor and 1 resistor.

From the project

ROS2 DIY Testbed

Just a PCB to organise the controller, isn't necessary for functionality but definitely needed for sanity. Pi Pico symbol and footprint taken from Ki Lime Pi (https://github.com/recursivenomad/ki-lime-pi-to-go), otherwise the rest is default KiCAD 10.0.

(When I say 12V, I really mean the direct battery output, which ranges from ~13.0V to ~16.0V)

The important part is the input, which are the top 3pin terminal block with 12V, GND and 5V, and the 4pin terminal block with MotorA and MotorB (the 4pin terminal could be direct-to-motor, but I opted for the board being the middle man).

Main components on the Mover

Mover bill of materials (BOM)

8 components, 7 distinct parts.

QtyPartRefs
1
TB6612FNG
U1
1
RaspberryPi_Pico
A1
1
BS170
Q2
1
Conn_01x03_Pin
J1
2
Conn_01x05_Pin
J2, J3
1
Conn_01x02_Pin
J4
1
10k
R1

Mover design files

The KiCad project lives in the tuxy/mover repository on GitHub; these links point at the commit this page was built from.

Mover: common questions

What microcontroller does the Mover use?

The Mover is built around the RaspberryPi_Pico, from the RP2040/RP2350 family.

How big is the Mover PCB?

The Mover measures 46.5 × 62.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Mover?

8 components, from 7 distinct parts. The full bill of materials is listed on this page.

Where can I download the Mover design files?

From the tuxy/mover repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Mover design in my own project?

Yes, under the terms of its GPL-3.0 license, which tuxy chose for the repository.

Can I test firmware for the Mover without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

Similar boards