HardLabs

Gabel

Tynogc·PickAndPlace_Electronic·Gabellicht/gabel.kicad_pcb

Gabel PCB layout, top view — open source AVR/Arduino board by Tynogc

About the Gabel PCB

Gabel is an open source AVR/Arduino PCB design by Tynogc, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 33 × 72 mm, with 35 components from 13 distinct parts.

Its main chip is the ATtiny45-20SU, from the AVR/Arduino family. Other key parts include the OPA2691. By type, the board carries 14 resistors, 9 connectors, 6 capacitors, 4 diodes and 2 ICs.

From the project

The Electronic-Side of an automatic SMT Pick&Place-System

Leiterplatten und embedded-Software für den Pick&Place Automaten

zur Verwendung dieses Repos sind noch die folgenden Repositorys nötig: https://github.com/Virtex7/PhilippsKicadBauteile https://github.com/ep092/library_toni.pretty

Diese enthalten KiCAD-Bauteile und Schaltplansymbole

Main components on the Gabel

ATtiny45-20SUOPA2691

Gabel bill of materials (BOM)

35 components, 13 distinct parts.

QtyPartRefs
1
ATtiny45-20SU
U1
1
OPA2691
U2
5
Conn_01x02_Male
J1, J2, J3, J4, J6
1
Conn_02x03_Odd_Even
J5
3
Conn_01x03_Female
J8, J9, J10
2
LED
D2, D3
2
LED
D4, D5
5
C
C1, C2, C3, C5, C6
1
C
C4
11
R
R1, R2, R3, R4, R9, R10, R11, R12 +3
1
1k
R14
1
4k
R15
1
56k
R16

Gabel design files

The KiCad project lives in the Tynogc/PickAndPlace_Electronic repository on GitHub; these links point at the commit this page was built from.

Gabel: common questions

What microcontroller does the Gabel use?

The Gabel is built around the ATtiny45-20SU, from the AVR/Arduino family.

How big is the Gabel PCB?

The Gabel measures 33 × 72 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Gabel?

35 components, from 13 distinct parts. The full bill of materials is listed on this page.

Where can I download the Gabel design files?

From the Tynogc/PickAndPlace_Electronic repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Gabel design in my own project?

Yes, under the terms of its GPL-3.0 license, which Tynogc chose for the repository.

Can I test firmware for the Gabel without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in PickAndPlace_Electronic

Similar boards