PAStoThrottle

vjapolitzer·PAStoThrottle·PCB/PAStoThrottle/PAStoThrottle.kicad_pcb

PAStoThrottle PCB layout, top view — open source board by vjapolitzer

About the PAStoThrottle PCB

PAStoThrottle is an open source PCB design by vjapolitzer, published on GitHub under the MIT license. It is a 2-layer board measuring 27.3 × 48.3 mm, with 19 components from 4 distinct parts.

By type, the board carries 9 resistors, 7 diodes and 3 capacitors.

It belongs with the audio and sensors designs in this gallery.

From the project

An intuitive e-bike controller that translates a simple PAS (Pedal Assist Sensor) signal into a smooth throttle output.

An Arduino Nano R4-based controller that converts a cadence-based PAS (Pedal Assist Sensor) signal into a smooth throttle output, giving a more responsive, torque-sensor-like feel on an e-bike without replacing the sensor hardware.

The PAS sensor produces pulses as you pedal — 14 per revolution on the supported sensor. The firmware measures pulse intervals to calculate cadence (RPM) in real time, applies asymmetric EMA smoothing to produce a natural acceleration/deceleration feel, and drives a 12-bit DAC output that feeds directly into the motor controller's throttle input.

PAStoThrottle bill of materials (BOM)

19 components, 4 distinct parts — part numbers from the project's BOM.

QtyPartRefs
7
ESD9X5.0ST5G
D1, D2, D3, D4, D5, D6, D7
3
CL05A474KO5NNNC
0.47μ
C1, C2, C3
4
RC0402FR-0710KL
10k
R1, R2, R3, R4
5
RC0402FR-07220RL
220
R5, R6, R7, R8, R9

PAStoThrottle design files

The KiCad project lives in the vjapolitzer/PAStoThrottle repository on GitHub; these links point at the commit this page was built from.

PAStoThrottle: common questions

How big is the PAStoThrottle PCB?

The PAStoThrottle measures 27.3 × 48.3 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the PAStoThrottle?

19 components, from 4 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the PAStoThrottle design files?

From the vjapolitzer/PAStoThrottle repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the PAStoThrottle design in my own project?

Yes, under the terms of its MIT license, which vjapolitzer chose for the repository.

Similar boards