Wireless-Split-Keyboard

yahyaGoblin·Wireless-Split-Keyboard·Wireless Split/Wireless Split.kicad_pcb

Wireless-Split-Keyboard PCB layout, top view — open source Nordic nRF board by yahyaGoblin

About the Wireless-Split-Keyboard PCB

Wireless-Split-Keyboard is an open source Nordic nRF PCB design by yahyaGoblin, published on GitHub under the MIT license. It is a 2-layer board measuring 281 × 81 mm, with 90 components from 5 distinct parts.

Its main chip is the XIAO-nRF52840-SMD, from the Nordic nRF family. By type, the board carries 42 switches, 42 diodes, 4 resistors and 2 ICs.

It belongs with the keyboards, iot & wireless and power & battery designs in this gallery.

From the project

Fully wireless split keyboard PCB powered by the nice!nano (nRF52840). No cables between halves or to host. ZMK firmware, KiCad design files and gerbers included.

A fully wireless split keyboard PCB, designed for ergonomic typing with no cables between halves or to the host.

- Wireless split design — no cable between halves - Bluetooth LE connectivity to host - Battery powered on each half - 1N4148 diodes for full anti-ghosting / n-key rollover - Low power design for extended battery life

Each half is an independent PCB with its own MCU and battery: - Left half — acts as the central device, connects to the host via Bluetooth - Right half — acts as a peripheral, communicates wirelessly to the left half

Main components on the Wireless-Split-Keyboard

Wireless-Split-Keyboard bill of materials (BOM)

90 components, 5 distinct parts — part numbers from the project's BOM.

QtyPartRefs
2
XIAO-nRF52840-SMD
U1, U2
42
SW_Push
SW1, SW2, SW3, SW4, SW5, SW6, SW7, SW8 +34
42
D
D1, D2, D3, D4, D5, D6, D7, D8 +34
2
806K
R1, R2
2
2M
R3, R4

Wireless-Split-Keyboard design files

The KiCad project lives in the yahyaGoblin/Wireless-Split-Keyboard repository on GitHub; these links point at the commit this page was built from.

Wireless-Split-Keyboard: common questions

What microcontroller does the Wireless-Split-Keyboard use?

The Wireless-Split-Keyboard is built around the XIAO-nRF52840-SMD, from the Nordic nRF family.

How big is the Wireless-Split-Keyboard PCB?

The Wireless-Split-Keyboard measures 281 × 81 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Wireless-Split-Keyboard?

90 components, from 5 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Wireless-Split-Keyboard design files?

From the yahyaGoblin/Wireless-Split-Keyboard repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Wireless-Split-Keyboard design in my own project?

Yes, under the terms of its MIT license, which yahyaGoblin chose for the repository.

Can I test firmware for the Wireless-Split-Keyboard without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug Nordic nRF firmware against it before you order a PCB.

Similar boards