Filament dryer

Yarnemeuris·filament-dryer·pcb/filament dryer.kicad_pcb

Filament dryer PCB layout, top view — open source RP2040/RP2350 board by Yarnemeuris

About the Filament dryer PCB

Filament dryer is an open source RP2040/RP2350 PCB design by Yarnemeuris, published on GitHub. It is a 2-layer board measuring 65 × 65 mm, with 20 components from 12 distinct parts.

Its main chip is the RaspberryPi_Pico, from the RP2040/RP2350 family. Other key parts include the SN65HVD230 and R-78E5.0-1.0. By type, the board carries 7 connectors, 6 resistors, 2 ICs, 2 transistors, 2 capacitors and 1 module.

From the project

A simple filament dryer for drying 1kg spools of filament.

Main components on the Filament dryer

Filament dryer bill of materials (BOM)

20 components, 12 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
SN65HVD230
U1
1
R-78E5.0-1.0
U2
1
RaspberryPi_Pico
A1
2
IRLZ44N
Q1, Q2
5
CONN_01X02
Conn_01x02
J1, J3, J4, J5, J7
2
C8465
Screw_Terminal
J2, J6
1
C531341
10µF
C1
1
C5259863
22µF
C2
2
100Ω
R1, R2
2
100KΩ
R3, R4
1
120Ω
R6
1
4.7KΩ
R7

Filament dryer design files

The KiCad project lives in the Yarnemeuris/filament-dryer repository on GitHub; these links point at the commit this page was built from.

Filament dryer: common questions

What microcontroller does the Filament dryer use?

The Filament dryer is built around the RaspberryPi_Pico, from the RP2040/RP2350 family.

How big is the Filament dryer PCB?

The Filament dryer measures 65 × 65 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Filament dryer?

20 components, from 12 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Filament dryer design files?

From the Yarnemeuris/filament-dryer repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Filament dryer design in my own project?

The repository has no license, so all rights stay with Yarnemeuris. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Filament dryer without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

Similar boards