ItsAnThermometer

z3phydev·ItsAnThermometer·Kicad/Thermometer.kicad_pcb

ItsAnThermometer PCB layout, top view — open source RP2040/RP2350 board by z3phydev

About the ItsAnThermometer PCB

ItsAnThermometer is an open source RP2040/RP2350 PCB design by z3phydev, published on GitHub. It is a 2-layer board measuring 90 × 90 mm, with 15 components from 13 distinct parts.

Its main chip is the XIAO-RP2040-DIP, from the RP2040/RP2350 family. Other key parts include the LM35-LP and AMS1117-3.3. By type, the board carries 5 diodes, 3 ICs, 3 resistors, 1 connector, 1 battery holder and 1 switch.

From the project

Its a simple Thermometer... what did you expect. It has 3 leds for tempature powered but a XIAO RP2040

You can use the toggle switch to change the power source

ItsAnThermometer, from the project README
From the project README

Main components on the ItsAnThermometer

ItsAnThermometer bill of materials (BOM)

15 components, 13 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
LM35-LP
Texas Instruments
U1
1
XIAO-RP2040-DIP
Raspberry Pi
U2
1
AMS1117-3.3
Texas Instruments
U3
1
USB_A
Molex
J1
1
Battery 4x AA
Keystone Electronics
BT1
1
SW_SPDT
E-Switch
SW1
1
RED
~
D1
1
GREEN
~
D2
1
BLUE
~
D3
2
D_Schottky
Vishay General Semiconductor
D4, D5
1
100nf
Vishay / BC Components
C1
1
75 Ohms
YAGEO
R1
2
10 Ohms
YAGEO
R2, R3

ItsAnThermometer design files

The KiCad project lives in the z3phydev/ItsAnThermometer repository on GitHub; these links point at the commit this page was built from.

ItsAnThermometer: common questions

What microcontroller does the ItsAnThermometer use?

The ItsAnThermometer is built around the XIAO-RP2040-DIP, from the RP2040/RP2350 family.

How big is the ItsAnThermometer PCB?

The ItsAnThermometer measures 90 × 90 mm, has 2 copper layers and is 1.600198 mm thick.

How many components are on the ItsAnThermometer?

15 components, from 13 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the ItsAnThermometer design files?

From the z3phydev/ItsAnThermometer repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the ItsAnThermometer design in my own project?

The repository has no license, so all rights stay with z3phydev. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the ItsAnThermometer without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

Similar boards