Mains fixture

2AMLogic·kicad-tools·boards/synthetic-mains-complete/mains_fixture.kicad_pcb

Mains fixture PCB layout, top view — open source STM32 board by 2AMLogic

About the Mains fixture PCB

Mains fixture is an open source STM32 PCB design by 2AMLogic, published on GitHub under the MIT license. It is a 2-layer board measuring 70 × 52 mm, with 9 components from 9 distinct parts.

Its main chip is the STM32F429ZIT6, from the STM32 family. Other key parts include the IS42S16400J-6TLI, AP2112K-3.3TRG1 and syn. By type, the board carries 6 ICs, 1 connector, 1 fuse and 1 relay.

From the project

Standalone Python tools for parsing and manipulating KiCad schematic and PCB files

Fully synthetic and public-safe: generated by generatefixture.py` with no inputs, not derived from any real or side-project design.

- mainsfixture.kicadpcb: 2-layer 70x52 mm board. Three mains footprints (/LINE, /FUSEDLINE, /NEUT, 150 V class) form a column "wall"; adjacent footprints' pads are 2.42 mm apart, so a trace squeezed between them gets ~1.1 mm to each side against the 1.6 mm class (IEC 60664-1, PD2, IIIa). Low-voltage links (/SENSEA..D, GND) between parts either side of the wall take the short path through those gaps unless creepage stops them. - voltagemap.json, netclassmap.json…

Main components on the Mains fixture

Mains fixture bill of materials (BOM)

9 components, 9 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
STM32F429ZIT6
syn
U1
1
IS42S16400J-6TLI
syn
U2
1
AP2112K-3.3TRG1
syn
U3
1
syn
U4
1
syn
U5
1
syn
U6
1
5V_INPUT
syn
J1
1
syn
F1
1
syn
K1

Mains fixture design files

The KiCad project lives in the 2AMLogic/kicad-tools repository on GitHub; these links point at the commit this page was built from.

Mains fixture: common questions

What microcontroller does the Mains fixture use?

The Mains fixture is built around the STM32F429ZIT6, from the STM32 family.

How big is the Mains fixture PCB?

The Mains fixture measures 70 × 52 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Mains fixture?

9 components, from 9 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Mains fixture design files?

From the 2AMLogic/kicad-tools repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.

Can I use the Mains fixture design in my own project?

Yes, under the terms of its MIT license, which 2AMLogic chose for the repository.

Can I test firmware for the Mains fixture without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

More boards in kicad-tools

Similar boards