Pip-Cam Button

AidansLab·Pip-Cam·Pip-Cam_Board/Pip-Cam_Button.kicad_pcb

Pip-Cam Button PCB layout, top view — open source ESP32 board by AidansLab

About the Pip-Cam Button PCB

Pip-Cam Button is an open source ESP32 PCB design by AidansLab, published on GitHub under the CERN-OHL-S-2.0 license. It is a 2-layer board measuring 21.3 × 10 mm, with 5 components from 5 distinct parts.

Its main chip is the XIAO-ESP32-S3-SMD, from the ESP32 family. By type, the board carries 3 connectors, 1 IC and 1 resistor.

It belongs with the power & battery designs in this gallery.

From the project

A camera for the Pip-Boy MK V by The Wand Company

The Pip-Cam is a small camera module that plugs into the USB-C port of a Pip-Boy (MK V or Pip-Boy 3000). It takes a grayscale photo, dithers it down to the Pip-Boy's screen format, and uploads it straight to the Pip-Boy's filesystem. You can then browse and delete photos from a Pip-Cam app on the Pip-Boy, and re-tune the brightness and contrast of the latest photo.

Main components on the Pip-Cam Button

Pip-Cam Button bill of materials (BOM)

5 components, 5 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
XIAO-ESP32-S3-SMD
U1
1
5V Boost
J1
1
USB C Plug
J2
1
SM02B-SRSS-TB(LF)(SN)
SM02B-SRSS-TB_LF__SN_
J3
1
R100K
R100k
R1

Pip-Cam Button design files

The KiCad project lives in the AidansLab/Pip-Cam repository on GitHub; these links point at the commit this page was built from.

Pip-Cam Button: common questions

What microcontroller does the Pip-Cam Button use?

The Pip-Cam Button is built around the XIAO-ESP32-S3-SMD, from the ESP32 family.

How big is the Pip-Cam Button PCB?

The Pip-Cam Button measures 21.3 × 10 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Pip-Cam Button?

5 components, from 5 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Pip-Cam Button design files?

From the AidansLab/Pip-Cam repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Pip-Cam Button design in my own project?

Yes, under the terms of its CERN-OHL-S-2.0 license, which AidansLab chose for the repository.

Can I test firmware for the Pip-Cam Button without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

More boards in Pip-Cam

Similar boards