Soil moisture sensor

Akashamulya24125·soil-moisture-sensor

Soil moisture sensor PCB layout, top view — open source board by Akashamulya24125

About the Soil moisture sensor PCB

Soil moisture sensor is an open source PCB design by Akashamulya24125, published on GitHub. It is a 2-layer board measuring 18.5 × 90.5 mm, with 11 components from 9 distinct parts.

Other key parts include the NE555P. By type, the board carries 4 capacitors, 4 resistors, 1 IC, 1 connector and 1 diode.

It belongs with the sensors designs in this gallery.

From the project

Hardware design and development of a soil moisture sensing system, including KiCad schematics, PCB layouts, and fabrication files.

\### Custom PCB Design · Capacitive Sensing · KiCad · Circuit Simulation

A custom soil-moisture sensing hardware project focused on PCB-level capacitive sensing, analog signal conditioning, circuit simulation, and hardware-to-software interface design.

This repository preserves the \\Soil Sensor V1 KiCad design\\, supporting design documentation, electrical-rule reports, and PCB fabrication outputs.

Main components on the Soil moisture sensor

Soil moisture sensor bill of materials (BOM)

11 components, 9 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
NE555P
U1
1
CONN_01X03
Conn_01x03
J1
1
1N4148
D1
1
1NF
1nF
C1
2
100NF
100nF
C2, C4
1
10NF
10nF
C3
1
1kΩ
R1
2
10kΩ
R2, R3
1
100kΩ
R4

Soil moisture sensor design files

The KiCad project lives in the Akashamulya24125/soil-moisture-sensor repository on GitHub; these links point at the commit this page was built from.

Soil moisture sensor: common questions

How big is the Soil moisture sensor PCB?

The Soil moisture sensor measures 18.5 × 90.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Soil moisture sensor?

11 components, from 9 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Soil moisture sensor design files?

From the Akashamulya24125/soil-moisture-sensor repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Soil moisture sensor design in my own project?

The repository has no license, so all rights stay with Akashamulya24125. Use it as a reference, and ask the author before reusing the design.

Similar boards