Laser Arcade Slave

AlexWheelock·Laser-Arcade-Project·KiCad/Target_Slave/Target_Slave.kicad_pcb

Laser Arcade Slave PCB layout, top view — open source PIC board by AlexWheelock

About the Laser Arcade Slave PCB

Laser Arcade Slave is an open source PIC PCB design by AlexWheelock, published on GitHub. It is a 2-layer board measuring 76.2 × 50.8 mm, with 36 components from 18 distinct parts.

Its main chip is the PIC16F1788-IP, from the PIC family. Other key parts include the TSSP4038 and TSOP53456. By type, the board carries 13 resistors, 6 diodes, 6 capacitors, 4 test points, 3 ICs and 3 connectors.

From the project

All documentation of the Laser Arcade Project

Main components on the Laser Arcade Slave

PIC16F1788-IPTSSP4038TSOP53456

Laser Arcade Slave bill of materials (BOM)

36 components, 18 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
PIC16F1788-IP
U1
1
TSSP4038
U2
1
TSOP53456
U3
1
ICSP
J1
2
I2C
J2, J3
1
I2C Address
SW1
4
~
TP1, TP2, TP3, TP4
1
1N4148
D1
4
IN-P32TRRRGB
D2, D3, D4, D5
1
LED
D6
4
1UF
1uF
C1, C2, C3, C4
1
22UF
22uF
C5
1
0.1UF
0.1uF
C6
8
330Ω
R1, R2, R3, R4, R5, R6, R7, R8
1
10kΩ
R9
2
90Ω
R10, R12
1
150Ω
R11
1
4.7kΩ
R13

Laser Arcade Slave design files

The KiCad project lives in the AlexWheelock/Laser-Arcade-Project repository on GitHub; these links point at the commit this page was built from.

Laser Arcade Slave: common questions

What microcontroller does the Laser Arcade Slave use?

The Laser Arcade Slave is built around the PIC16F1788-IP, from the PIC family.

How big is the Laser Arcade Slave PCB?

The Laser Arcade Slave measures 76.2 × 50.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Laser Arcade Slave?

36 components, from 18 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Laser Arcade Slave design files?

From the AlexWheelock/Laser-Arcade-Project repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Laser Arcade Slave design in my own project?

The repository has no license, so all rights stay with AlexWheelock. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Laser Arcade Slave without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug PIC firmware against it before you order a PCB.

More boards in Laser-Arcade-Project

Similar boards