MT6835 hub rev a
aliahumanoid·alia-humanoid-core·hardware/electronics/MT6835_hub_rev_a/MT6835_hub_rev_a.kicad_pcb
About the MT6835 hub rev a PCB
MT6835 hub rev a is an open source PCB design by aliahumanoid, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 42 × 17 mm, with 4 components from 2 distinct parts.
It belongs with the robotics & motion designs in this gallery.
From the project
Humanoid research project (Phase 0): firmware, host software, STL files and electronics for tendon-driven joints inside real human proportions. GPLv3 software, CC BY-NC-ND hardware files.
Passive breakout board that routes up to three MT6835 SPI encoder modules into the RJ45 encoder port used by jointcontrollerboard/revdlogic (J2).
- Aggregate three encoder channels into one RJ45 link - Preserve the SPI pin mapping expected by the controller board - Keep the hub fully passive: no active components, only connector routing
This connector maps directly to revdlogic encoder connector J2.
MT6835 hub rev a bill of materials (BOM)
4 components, 2 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | RJHSE5380 8P8C Amphenol | RJ45_Amphenol_RJHSE5380 | J0 |
| 3 | 53398-0671 Conn_01x06_Pin Molex | Molex_PicoBlade_53398-0671_1x06-1MP_P1.25mm_Vertical | J1, J2, J3 |
MT6835 hub rev a design files
The KiCad project lives in the aliahumanoid/alia-humanoid-core repository on GitHub; these links point at the commit this page was built from.
MT6835 hub rev a: common questions
How big is the MT6835 hub rev a PCB?
The MT6835 hub rev a measures 42 × 17 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the MT6835 hub rev a?
4 components, from 2 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the MT6835 hub rev a design files?
From the aliahumanoid/alia-humanoid-core repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.
Can I use the MT6835 hub rev a design in my own project?
Yes, under the terms of its GPL-3.0 license, which aliahumanoid chose for the repository.
More boards in alia-humanoid-core
Similar boards
Stack chan
stack-chan
50 × 50 mm33 parts2LApache-2.01.7kCube batteryboard
willem-pennings
95 × 95 mm4 parts2LGPL-3.01.1kTrollerv2
rene-dev
100 × 75 mm33 parts4LGPL-3.0979Powerstep
rene-dev
95.2 × 71.5 mm28 parts4LGPL-3.097911ua
rene-dev
57.3 × 19 mm26 parts2LGPL-3.0979Diff driver
rene-dev
32 × 22 mm14 parts2LGPL-3.0979