Tombask

Anderman·tombask·kiCad/Isolated_RS485_Bridge.kicad_pcb

Tombask PCB layout, top view — open source ESP32 board by Anderman

About the Tombask PCB

Tombask is an open source ESP32 PCB design by Anderman, published on GitHub. It is a 2-layer board measuring 22 × 53.5 mm, with 21 components from 15 distinct parts.

Its main chip is the ESP32-S3-MINI-1, from the ESP32 family. Other key parts include the AP63203WU, π122U31, THVD2450DR and B. By type, the board carries 7 capacitors, 5 ICs, 4 diodes, 2 resistors, 1 module and 1 inductor.

It belongs with the iot & wireless designs in this gallery.

From the project

Slave can send after a poll frame. Slave is ready sending when the last padding byte is 0x55 To write byte 0x08 must be 0x02

Slave can send after a poll frame. Slave is ready sending when the last padding byte is 0x55 To write byte 0x08 must be 0x02

Aansluiting Rs485 signal for wired controller on H1(pos) and H2(neg) of the XT3 connector

Tombask, from the project README
From the project README

Main components on the Tombask

Tombask bill of materials (BOM)

21 components, 15 distinct parts.

QtyPartRefs
1
ESP32-S3-MINI-1
U1
1
AP63203WU
U2
2
π122U31
U3, U4
1
THVD2450DR
U5
1
B
A1
1
MEE1S0303SC
PS1
1
SMF24A
D1
1
WS2812B-2020
D2
2
SS14
D3, D4
1
4.7uH
L1
1
470uF
C1
3
100nF
C2, C3, C6
3
22uF
C4, C5, C8
1
10R
R1
1
10K
R2

Tombask design files

The KiCad project lives in the Anderman/tombask repository on GitHub; these links point at the commit this page was built from.

Tombask: common questions

What microcontroller does the Tombask use?

The Tombask is built around the ESP32-S3-MINI-1, from the ESP32 family.

How big is the Tombask PCB?

The Tombask measures 22 × 53.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Tombask?

21 components, from 15 distinct parts. The full bill of materials is listed on this page.

Where can I download the Tombask design files?

From the Anderman/tombask repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Tombask design in my own project?

The repository has no license, so all rights stay with Anderman. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Tombask without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

Similar boards