Controller

AndreHatu·MarioKart·schematics/controller.kicad_pcb

Controller PCB layout, top view — open source ESP32 board by AndreHatu

About the Controller PCB

Controller is an open source ESP32 PCB design by AndreHatu, published on GitHub under the MIT license. It is a 2-layer board measuring 99.3 × 47.2 mm, with 33 components from 14 distinct parts.

Its main chip is the ESP32-SOLO-1, from the ESP32 family. Other key parts include the AZ1117CD-3.3TRG1. By type, the board carries 11 resistors, 7 switches, 7 capacitors, 3 connectors, 2 ICs and 2 transistors.

It belongs with the iot & wireless designs in this gallery.

From the project

Senior Design Project using ESP32s to remake Mario Kart with RC Cars

ECE477 Senior Design at Purdue University.

Inside the menuconfig, you might need to set the option in case your ESP32 only has one core (like the ones we are using for the project) Then you can build and flash with

Main components on the Controller

AZ1117CD-3.3TRG1ESP32-SOLO-1

Controller bill of materials (BOM)

33 components, 14 distinct parts.

QtyPartRefs
1
AZ1117CD-3.3TRG1
IC1
1
ESP32-SOLO-1
IC2
2
SS8050-G
Q1, Q2
2
Conn_01x05
J1, J2
1
Conn_01x06
J3
2
SW_Push
SW1, SW2
5
SW_Push_Dual
SW3, SW4, SW5, SW6, SW7
1
LED
D1
2
0.1uF
C1, C2
2
100nF
C3, C5
1
22uF
C4
2
10uF
C6, C7
10
10k
R1, R2, R3, R4, R5, R6, R7, R8 +2
1
0
R9

Controller design files

The KiCad project lives in the AndreHatu/MarioKart repository on GitHub; these links point at the commit this page was built from.

Controller: common questions

What microcontroller does the Controller use?

The Controller is built around the ESP32-SOLO-1, from the ESP32 family.

How big is the Controller PCB?

The Controller measures 99.3 × 47.2 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Controller?

33 components, from 14 distinct parts. The full bill of materials is listed on this page.

Where can I download the Controller design files?

From the AndreHatu/MarioKart repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Controller design in my own project?

Yes, under the terms of its MIT license, which AndreHatu chose for the repository.

Can I test firmware for the Controller without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

More boards in MarioKart

Similar boards