Car (1)

AndreHatu·MarioKart·car/car (1).kicad_pcb

Car (1) PCB layout, top view — open source ESP32 board by AndreHatu

About the Car (1) PCB

Car (1) is an open source ESP32 PCB design by AndreHatu, published on GitHub under the MIT license. It is a 2-layer board measuring 79.7 × 66 mm, with 29 components from 14 distinct parts.

Its main chip is the ESP32-SOLO-1, from the ESP32 family. Other key parts include the L298HN. By type, the board carries 8 diodes, 8 resistors, 5 connectors, 4 capacitors, 2 ICs and 2 switches.

It belongs with the iot & wireless designs in this gallery.

From the project

Senior Design Project using ESP32s to remake Mario Kart with RC Cars

ECE477 Senior Design at Purdue University.

Inside the menuconfig, you might need to set the option in case your ESP32 only has one core (like the ones we are using for the project) Then you can build and flash with

Main components on the Car (1)

ESP32-SOLO-1L298HN

Car (1) bill of materials (BOM)

29 components, 14 distinct parts.

QtyPartRefs
1
ESP32-SOLO-1
IC1
1
L298HN
U1
1
Conn_01x06_Female
J1
1
Conn_01x09_Female
J2
1
Conn_01x02_Female
J3
1
Conn_01x04_Male
J4
1
Conn_01x05_Female
J5
1
SW_Push
SW1
1
SW_SPDT
SW2
8
IN4148
D1, D2, D3, D4, D5, D6, D7, D8
2
100nF
C1, C2
2
100uF
C3, C4
2
10k
R1, R2
6
20
R3, R4, R5, R6, R7, R8

Car (1) design files

The KiCad project lives in the AndreHatu/MarioKart repository on GitHub; these links point at the commit this page was built from.

Car (1): common questions

What microcontroller does the Car (1) use?

The Car (1) is built around the ESP32-SOLO-1, from the ESP32 family.

How big is the Car (1) PCB?

The Car (1) measures 79.7 × 66 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Car (1)?

29 components, from 14 distinct parts. The full bill of materials is listed on this page.

Where can I download the Car (1) design files?

From the AndreHatu/MarioKart repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Car (1) design in my own project?

Yes, under the terms of its MIT license, which AndreHatu chose for the repository.

Can I test firmware for the Car (1) without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug ESP32 firmware against it before you order a PCB.

More boards in MarioKart

Similar boards